Instructions for the User
Modifying the data set
Once automatic cooking has started, its duration can be changed.
When the 
and 
symbols are steady and cooking is in progress, or the oven is in standby status waiting for cooking to start, press PT1 once.
The 
symbol starts flashing and PT1 can be turned to change the set duration.
Press PT1 again; the 
symbol goes out, the 
symbol will start to flash, and the cooking start time will be displayed on DSP1. The cooking start time can be increased or decreased by turning PT1.
A few seconds after the last change, the 
e 
symbols will appear (in steady mode) on DSP1 and automatic cooking will restart with the new settings.
Once cooking has been programmed, before it starts all the lamps on the control panel will be on, except for DSP2 which will illuminate when cooking has started, showing the set temperature.
7.6Secondary menu
This appliance also has a concealed "secondary menu" allowing the user to:
1Activate or deactivate the child safety device (
);
2Activate or deactivate the Show Room function (which disables all the heating elements so that only the control panel works);
3Activate or deactivate the function which limits the maximum power absorption to 2300 W;
7.6.1 Child safety lock-out function
With the oven in OFF status (see point “7.2 Operating modes”) keep PT1 pressed until the message OFF SHO appears on DSP1. Now press PT1 until the message “OFF BLOC” appears on DPS1.
Turn PT1 to the right or left to activate (ON BLOC) or deactivate (OFF BLOC) this function, which locks out all the functions and knobs after 3 minutes of operation without any command from the user (when this system is active, the 
symbol appears on DPS2).
After setting the parameter required, press PT2 to return the oven to the initial standby status.
To exit the lockout status temporarily to modify a cooking program or
select a different function, keep PT1 pressed until the 
symbol disappears from DSP2. The required changes can now be made, and 3 minutes after the last setting is made the lockout will come into operation again.
To deactivate the lockout permanently, access the secondary menu and switch the function off as described in this section.
43