Smeg CE92GPX Safety Precautions, Intended USE, Never Attempt to Repair the Appliance Yourself

Page 4

Safety instructions

3. SAFETY PRECAUTIONS

ELECTRICAL CONNECTION: REFER TO THE INSTALLATION INSTRUCTIONS WITH REGARD TO GAS, ELECTRICITY SUPPLY AND VENTILATION REQUIREMENTS.

IN YOUR INTEREST AND TO ENSURE YOUR SAFETY, BY LAW ALL GAS-FIRED HOUSEHOLD APPLIANCES MUST ONLY BE INSTALLED AND SERVICED BY QUALIFIED STAFF, IN ACCORDANCE WITH THE RELEVANT REGULATIONS.

INSTALLATION TECHNICIANS ARE COMMITTED TO WORKING TO THE HIGHEST STANDARDS.

GAS OR ELECTRIC APPLIANCES MUST ALWAYS BE DISCONNECTED BY SUITABLY SKILLED PEOPLE. THE PLUG TO BE CONNECTED TO THE POWER SUPPLY LEAD AND THE RELATIVE SOCKET MUST BE OF THE SAME TYPE AND COMPLY WITH THE RELEVANT REGULATIONS.

THE SOCKET MUST BE ACCESSIBLE AFTER THE APPLIANCE IS BUILT IN.

NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEAD.

THIS APPLIANCE MUST NEVER BE INSTALLED ON A STAND.

IT IS OBLIGATORY FOR ALL ELECTRICAL SYSTEMS TO BE GROUNDED ACCORDING TO THE METHODS REQUIRED BY SAFETY RULES.

IMMEDIATELY AFTER INSTALLATION, CARRY OUT A QUICK TEST ON THE APPLIANCE FOLLOWING THE INSTRUCTIONS PROVIDED LATER IN THIS MANUAL. SHOULD THE APPLIANCE NOT FUNCTION, DISCONNECT IT FROM THE SUPPLY AND CALL THE NEAREST TECHNICAL ASSISTANCE CENTRE.

NEVER ATTEMPT TO REPAIR THE APPLIANCE YOURSELF.

NEVER PLACE PANS WITH BOTTOMS WHICH ARE NOT PERFECTLY FLAT AND SMOOTH ON THE HOB GRIDS.

NEVER USE PANS OR GRIDDLE PLATES WHICH PROJECT BEYOND THE OUTSIDE EDGE OF THE HOB.

NEVER PLACE FLAMMABLE OBJECTS IN THE OVEN: IF IT SHOULD ACCIDENTALLY BE SWITCHED ON, THIS MIGHT CAUSE A FIRE.

DURING USE THE APPLIANCE BECOMES VERY HOT. TAKE CARE NEVER TO TOUCH THE HEATING ELEMENTS INSIDE THE OVEN.

THE USE OF THIS APPLIANCE IS NOT PERMITTED TO PEOPLE (INCLUDING CHILDREN) OF REDUCED PHYSICAL AND MENTAL ABILITY, OR LACKING IN EXPERIENCE IN THE USE OF ELECTRICAL APPLIANCES, UNLESS THEY ARE SUPERVISED OR INSTRUCTED BY ADULTS OR PEOPLE RESPONSIBLE FOR THEIR SAFETY.

ALWAYS CHECK THAT THE CONTROL KNOBS ARE IN THE 0 (OFF) POSITION WHEN YOU FINISH USING THE OVEN.

BEFORE THE APPLIANCE IS PUT INTO OPERATION, ALL THE LABELS AND PROTECTIVE FILMS APPLIED INSIDE OR OUTSIDE MUST BE REMOVED.

4. INTENDED USE

THE APPLIANCE IS BUILT TO PERFORM THE FOLLOWING FUNCTION: COOKING AND REHEATING OF FOOD; ALL OTHER USES ARE CONSIDERED IMPROPER.

The manufacturer declines all responsibility for injury or damage caused by failure to comply with the above regulations or deriving from tampering with even just one part of the appliance and the use of non-original spare parts.

37

Image 4
Contents Sommario Precautions for USE Plate Must not be RemovedRecycling Instructions OUR Environment Policy Intended USE Safety PrecautionsNever Attempt to Repair the Appliance Yourself Getting to Know Your Oven General DescriptionAvailable Accessories Before InstallationAccessories available on request Instructions for the user Description of the Controls on the Front Panel Main Oven Temperature Selection Knob PT1 Auxiliary Oven Functions / Temperature Selection KnobMain Oven Functions Selection Knob PT2 HOB Burner Control KnobUsing the Main Oven Setting the current timeFirst use Selecting a functionProgrammed cooking procedures 10.4.1Semiautomatic cookingModifying the data set 10.4.2Automatic cookingModifying the data set during cooking Cooking with selection of a recipeAutomatic cooking with selection of a recipe Making permanent changes to a recipe Table of predefined recipes Secondary menu Using the Secondary Oven Cooking in the Oven Description of the selected functionsHints on Using the Accessories Cooking Hints and TipsCooking tables Using the HOB Practical hints for using the hob burnersPan diameters BurnersCleaning and Maintenance Pyrolysis automatic oven cleaning on some models only 14.6.1Before starting the automatic cleaning cycle14.6.2Setting the cleaning cycle Extraordinary Maintenance Changing the light bulbRemoving the door Removing the door sealWhat to do if Oven display is completely offOven does not heat up Controls do not respondInstalling the Appliance Electrical connectionExtraction of the products of combustion Ventilation requirementsConnection to gas Connection of natural and town gas 16.4.2Connection to LPGReplacement of nozzles on the hob Adaptation to Different Types of GASBurner and nozzle characteristics table Arrangement of the burners on the hobRegulation of the hob burner minimum level for LPG Regulation of the hob burner minimum level for natural gasPositioning and levelling the appliance depending on model