Smeg CE92GPX manual Installing the Appliance, Electrical connection

Page 26

Instructions for the installer

16.INSTALLING THE APPLIANCE

The appliance must be installed by a qualified technician and according to the standards in force.

This appliance may be installed next to a wall which is higher than the appliance, with a minimum distance of 5 cm from the side of the appliance, as shown in drawings A and B showing the correct installation conditions. Any wall cupboards or shelves must be at a distance of at least 75 cm above the work surface.

A)

Built-in appliance

16.1Electrical connection

B)

Free-standing appliance

Make sure the voltage and the cross-section of the power cord match the specifications indicated on the rating plated positioned in the storage compartment. Do not remove this plate for any reason.

If the appliance is connected to the supply by means of a fixed connection, install a multipolar cut-out device on the line, with contact opening distance equal to or greater than 3 mm located near the appliance and in an easily reachable position.

Connection to the supply may be fixed or with plug and socket. In the latter case the plug and socket must be suitable for the cable employed and conform with the regulations in force. Regardless of the type of connection, the appliance absolutely must be earthed. Before connection make sure that the supply line is suitably earthed. Avoid the use of reducers, adapters or shunts which may cause overheating.

59

Image 26
Contents Sommario Precautions for USE Plate Must not be RemovedRecycling Instructions OUR Environment Policy Never Attempt to Repair the Appliance Yourself Safety PrecautionsIntended USE Getting to Know Your Oven General DescriptionAccessories available on request Before InstallationAvailable Accessories Instructions for the user Description of the Controls on the Front Panel Main Oven Functions Selection Knob PT2 Main Oven Temperature Selection Knob PT1Auxiliary Oven Functions / Temperature Selection Knob HOB Burner Control KnobFirst use Using the Main OvenSetting the current time Selecting a functionModifying the data set Programmed cooking procedures10.4.1Semiautomatic cooking 10.4.2Automatic cookingAutomatic cooking with selection of a recipe Cooking with selection of a recipeModifying the data set during cooking Making permanent changes to a recipe Table of predefined recipes Secondary menu Using the Secondary Oven Cooking in the Oven Description of the selected functionsHints on Using the Accessories Cooking Hints and TipsCooking tables Pan diameters Using the HOBPractical hints for using the hob burners BurnersCleaning and Maintenance Pyrolysis automatic oven cleaning on some models only 14.6.1Before starting the automatic cleaning cycle14.6.2Setting the cleaning cycle Removing the door Extraordinary MaintenanceChanging the light bulb Removing the door sealOven does not heat up What to do ifOven display is completely off Controls do not respondInstalling the Appliance Electrical connectionConnection to gas Ventilation requirementsExtraction of the products of combustion Connection of natural and town gas 16.4.2Connection to LPGReplacement of nozzles on the hob Adaptation to Different Types of GASBurner and nozzle characteristics table Arrangement of the burners on the hobPositioning and levelling the appliance depending on model Regulation of the hob burner minimum level for natural gasRegulation of the hob burner minimum level for LPG