W O L F STEAMER MODULE U S E & C A R E
AUTOMATIC DRAIN O P E R AT I O N | TIMER O P E R AT I O N |
IMPORTANT NOTE: The steamer module must be installed with a drain connection and access to the drain through the base cabinet.
The DRAIN touch pad operation is functional only while the unit is in Idle mode. The unit must be unlocked and not in operation. Refer to the illustration below.
To activate the drain:
1)Touch DRAIN for 3 seconds. The unit will beep, the light in the DRAIN touch pad will illuminate and the drain valve will open for a period of 2 minutes. This should be enough time to drain a full capacity of water. This operation may be repeated as many times as needed to completely drain the steamer basin.
2)Touch DRAIN again while in the drain mode operation to shut the drain valve. The light in the DRAIN touch pad will go out.
The control panel of the steamer module has an independent
To start the timer, touch the ”+” or
A warning beep will sound when the timer has 1 minute left and begins to countdown in seconds starting at 59.
A signal will beep when time has expired and will continue to beep every 30 seconds.
Touch CLEAR to reset the timer.
If you do not have a fixed drain connec- tion, use caution when draining hot water from the steamer basin to avoid burns. Use a
CLEAR |
touch pad |
DRAIN |
touch pad |
Touch control panel
”+” and |
symbols |
Timer |
display |
Timer controls
10