True Manufacturing Company T-35 Freezers Defrost Time Clock Operation Grasslin Timer

Page 15

True Food Service Equipment, Inc.

INSTALLATION / OPERATION INSTRUCTIONS

FREEZERS DEFROST TIME CLOCK OPERATION (Grasslin Timer)

RECOMMENDED DEFROST

SETTINGS:

True Manufacturing has factory set your defrost time clock to a recommended time and duration defrost scenario.

All refrigeration equipment operating below 30°F will accumulate frost on the evaporator coil and will require routine defrost. Your True equipment has been designed for three defrost periods (6:00 a.m., 2:00 p.m. and 10:00 p.m.). If you decide to deviate from these defrost time

settings please follow the procedures for adjustment below.

REQUIRED TOOLS:

•Phillips Screwdriver

•1/4” Nut Driver or Socket

Locating The Defrost Timer:

Take off louvered grill assembly by removing four (4) corner screws.

Single Door Models:

Defrost timer is located in the lower right corner behind the louvered grill (inside galvanized electrical box).

Two Door Models:

Defrost timer is located in the middle of the cabinet, behind the louvered grill. Timer is mounted to the left of the centered ballast box (Inside of gray timer box).

Your True freezer contains a defrost system that is temperature terminated, however the time clock has been designed with a time termination back-up so that the defrost period will not exceed thirty minutes. While True requires a minimum 3 defrost periods not to exceed 30 minutes the procedure on this page should be followed to customize your specific needs.

Notice:

If timer is not set for a minimum of 3

defrost per day for 30 minutes each, the coil may develop excessive frost. This may lead to system failure and product loss, which is not covered under warranty.

The following procedure may be followed to customize your needs.

High usage, high temperature, and high humidity may require 4 defrost settings per day.

WARNING:

Always follow the manufacturer’s

recommended settings when

programming the amount and duration

of the defrost cycles.

STEP 1

The white tabs located on the outmost area of the time clock have been factory set for (6:00 a.m., 2:00 p.m., and 10:00 p.m.). Each tab represents 15 minutes of defrost time. Notice that at each defrost time two white tabs are set for 15 minutes each for a total of 30 minutes of defrost.

STEP 2

In order to program the time to begin the defrost cycle, flip the white tabs out to set the defrost time. To eliminate a defrost time flip the white tabs back toward the center of the Defrost Timer.

STEP 3

True recommends a 30 minute defrost cycle three times per day.

Three Door Models:

Defrost timer is located on the left upright post behind the louvered grill (Inside of gray timer box).

Defrost Timer Box Image 1

Setting the timer:

(UNPLUG UNIT FROM

POWER SUPPLY!)

DO NOT SET THE TIME BY

ROTATING THE “OUTER” DIAL. Turn the minute hand clockwise until the time of day on the outer dial is aligned with the triangle marker on the inner dial (two o’clock position).

Adjusting The Defrost Timer: (time initiated, time or temperature terminated)

Outer most dial. White tabs represent 15 minutes of defrost time.

Time of day.

Inner most dial.

 

Defrost Timer Image 2

 

13

www.truemfg.com

13

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Series Freezer / Refrigerator Swing Slide Door True Food Service Equipment, Inc Safety Precautions Safety Information Refrigerant Disposal Proper Disposal of the Freezer / RefrigeratorUSE of Extension Cords Before You Throw Away Your Old Refrigerator or FreezerNorth America Use Only HOW to Connect ElectricityInstallation / Operation Instructions Ownership Required ToolsUncrating Locating LevelingRemote Units This section applies to remotes only Unit leveling Securing Castors and LegsFinal Location Installing Optional Castors on a T-12FGConductors and Circuits Sealing Cabinet to Floor Electrical InstructionsReplacement Parts StartupRecommendation Light Switch Location Shelving Installation / Operation & Light Switch LocationShelf & Organizer Installation Wire ShelvesFreezers Defrost Time Clock Operation Grasslin Timer Starts but Trips If the Compressor willNot RUN If the Motor CompressorDefrost Time Clock Light Cover Installation for T-12FG Required Tools MAINTENANCE, Care & Cleaning Cleaning the Condenser CoilImportant Warranty Information Danfoss Temperature Control High Altitude Only Temperature Control Adjustment for High Altitude onlyStainless Steel Equipment Care and Cleaning IDL Integrated Door Lighting Light Bulb ReplacementIDL Integrated Door Lighting Interior LightsA. Warranty Information U.S.A & Canada only

T-35 specifications

True Manufacturing Company has long been synonymous with excellence in refrigeration equipment, and the T-35 model is no exception. This commercial refrigeration unit exemplifies the company's commitment to design, durability, and user-friendly features, making it a top choice for restaurants, cafes, and other foodservice operations.

The True T-35 is a powerful and highly efficient one-section refrigerator that features a spacious interior, ideal for holding a significant quantity of perishable items. This reach-in refrigerator is built with a stainless-steel exterior, ensuring not only a sleek appearance but also durability against the rigors of any commercial kitchen environment. The interior is comprised of aluminum, which provides easy cleaning and maintenance, ensuring adherence to health and safety standards.

One of the standout features of the T-35 is its advanced refrigeration system. It is equipped with a factory-balanced refrigeration system that utilizes environmentally friendly refrigerant, enhancing energy efficiency while providing excellent temperature control. The unit maintains temperatures ranging from 33°F to 38°F, crucial for preserving the freshness of perishable items.

In addition to its robust cooling capabilities, the T-35 incorporates a self-contained capillary tube system that delivers superior cooling performance even in high-demand situations. The evaporator fan motor runs continuously to ensure optimal air circulation, promoting uniform temperatures throughout the interior.

The True T-35 is designed with user comfort in mind. It comes with a set of adjustable, heavy-duty PVC-coated wire shelves, which allow operators to customize the layout based on their specific storage needs. The ergonomic door handles are easy to grip and open, making access to stored items seamless during busy service periods.

For energy efficiency, the T-35 includes features such as LED interior lighting, which not only enhances visibility but also reduces overall energy consumption. The unit is also designed to operate quietly, allowing it to fit seamlessly into any environment without causing disturbances.

Overall, the True Manufacturing Company T-35 combines functionality and efficiency in a beautifully designed package. Its advanced cooling technology, flexible storage options, and durable construction make it an indispensable asset for any foodservice operation, ensuring that food items remain fresh and safe for consumption. With a solid warranty and dedicated customer support, the T-35 represents the high standard of quality and reliability that True Manufacturing is renowned for.
Top Page Image Contents