Whirlpool SF397PEY, SF387PEY, SF387PCY manual Cleaning the burners

Page 33

Cleaning the burners

The burner caps should be routinely removed

and cleaned. Always clean the burner caps after a spillover. Keeping the burner caps clean will prevent improper ignition and an uneven flame.

To clean, pull the burner cap straight up from the burner base. Remove the trim ring (if equipped) and burner pan. (Burner pan and trim ring must be replaced over burner base before replacing burner cap. Do not operate burners without burner pan and trim ring in place.) Clean burner cap, trim ring and burner pan with warm, soapy water and a sponge. You can also clean with a nonabrasive scrubbing pad or cleanser. Do not clean burner cap, trim ring or burner pan in a dishwasher or self-cleaning oven.

For proper flow of gas and ignition of the burner, DO NOT ALLOW SPILLS, FOOD,

CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS TUBE OPEN- ING. If the opening or the orifice, located inside the opening, becomes soiled or clogged, use a cotton swab or a paper towel to clean the area.

Gas must flow freely through the small hole in the brass orifice for the burner to light properly. This area must be free of any soil and be kept protected from boilovers or spillovers. ALWAYS keep the burner caps in place whenever a surface burner is in use.

After cleaning the gas tube opening,

replace the burner cap, trim ring and burner pan. Occasionally check the burner flames for

proper size and shape as shown. A good flame is blue in color. If flames lift off ports, are yellow, or are noisy when turned off, you may need to clean the burners. ff ports are clogged, clean with a straight pin. Do not enlarge or distort port. Do not use a wooden toothpick. lf adjustment is needed, call a qualified technician for service.

To replace burner cap, make sure cap is properly aligned and leveled. Find the recessed locating tabs on the burner cap (see illustration) and place cap over the white ignitor in the burner base.

Turn the burner on to determine if it will light. ff the burner does not light after cleaning, contact an authorized Whirlpool service techni- cian. Do not service the sealed burner yoursetf.

Typical surface burner flame

c?-Locating tabs

33

Image 33
Contents Caring SELF-CLEANING GAS RangeThank you for buying a Whirlpool appliance Your safety is important to usSerial Number Dealer Purchase DateGeneral Important Safety InstructionsWhen using the oven When using the cooktopKnow where your main gas shutoff valve is located Keep range vents unobstructedGrease Care and cleaningControl Par&And FeaturesUsing the surface burners Using Your RangeBurner heat settings This SectionSetting Recommended USE Case of a prolonged power failureCookware tips Home canning information6th oven rack position Roasting rack Positioning racks and pansFood Frozen pies, large roasts, turkeysFor best air circulation MealtimerElectronic oven control Display/clockSetting the clock Using the electronic Minute TimerCommand pads Audible signals Using the Off/Cancel padTo cancel Minute Timer Push Timer Off pad. The time of day willBaking/roasting Broiling Adjusting the oven temperature controlBroiling tips To broil at a lower temperatureEnergy saving tips Broiling rack position chartPosition the oven racks properly and put food in the oven Using the electronic Mealtimer controlDisplay will count down the baking/ roasting time in minutes Method Z-Using Stop TimeDisplay will count down the baking/ roasting time in minutes Position the oven racks properly and put food in the oven Page Position the oven racks property and put food in the oven Method Z-Using Delay Start Time and Stop TimeMethod 3-Using Cook Time and Stop Time Page Page Oven vent Storage drawerAnti-tip bracket How the cycle works Using The Self-Cleaning CycleBefore you start This Section PawPageRemove any pots and pans being stored in the oven Setting the controlsSkip to Step Page Caring For Your Range To stop the Self-Cleaning cycle at any timeSpecial tips This Section PawCleaning the contoured well areas Surface burner gratesSurface burners and cooktop Cleaning the burners HOW to Clean Cleaning chartPart What OFFCooktop light Using and replacing the light bulbsTo replace the oven light Oven lightSolution ProblemYou Need Assistance Or Sewice Before calling for assistancePossible Cause There has been a power failureIf you need service If you are not satisfied with how the problem was solvedIf you need FSP replace- ment parts Length of Warranty Gas Cooking Product WarrantyWarranty Full ONE-YEAR