Whirlpool W10459123B Installation Requirements, Tools and Parts, Location Requirements

Page 4

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.

Location Requirements

IMPORTANT: Observe all governing codes and ordinances. Do not obstruct flow of combustion and ventilation air.

■ It is the installer’s responsibility to comply with installation

Tools needed

■Tape measure

■Flat-blade screwdriver

■Phillips screwdriver

■Level

■Hand or electric drill

■Hammer

■Wrench or pliers

■Pipe wrench

■¹⁵⁄₁₆" combination wrench

■¼" drive ratchet

■³⁄₈" nut driver

■¹⁄₈" (3.2 mm) drill bit (for wood floors)

■Marker or pencil

■Pipe-joint compound resistant to LP gas

■Noncorrosive leak-detection solution

For LP/Natural Gas

Conversions

■³⁄₈" combination wrench

■½" combination wrench

■⁵⁄₈" combination wrench

■7 mm (⁹⁄₃₂") nut driver

■Quadrex®† or Phillips screwdriver

■Masking tape

clearances specified on the model/serial rating plate. The

model/serial rating plate is located on the oven frame behind

the left side of the broiler door.

A

A. Model/serial rating plate location

■ The range should be located for convenient use in the kitchen.

■ Recessed installations must provide complete enclosure of

the sides and rear of the range.

■ To eliminate the risk of burns or fire by reaching over heated

surface units, cabinet storage space located above the

surface units should be avoided. If cabinet storage is to be

Parts supplied

Check that all parts are included.

A

B

A.Anti-tip bracket

B.#12 x 1⁵⁄₈" screws (2)

■Literature bag

■Conversion orifice spuds (inside bag containing literature)

■Anti-tip bracket must be securely mounted to floor or wall. Thickness of flooring may require longer screws to anchor bracket to floor.

Parts needed

Check local codes and consult gas supplier. Check existing gas supply and electrical supply. See “Electrical Requirements” and “Gas Supply Requirements” sections.

†® QUADREX is a registered trademark of NLW Holdings, Inc.

provided, the risk can be reduced by installing a range hood

that projects horizontally a minimum of 5" (12.7 cm) beyond

the bottom of the cabinets.

■ All openings in the wall or floor where range is to be installed

must be sealed.

■ Do not seal the range to the side cabinets.

■ Cabinet opening dimensions that are shown must be used.

Given dimensions are minimum clearances.

■ The anti-tip bracket must be installed. To install the anti-tip

bracket shipped with the range, see “Install Anti-Tip Bracket”

section.

■ Grounded electrical supply is required. See “Electrical

Requirements” section. Proper gas supply connection must

be available. See “Gas Supply Requirements” section.

■ Contact a qualified floor covering installer to check that the

floor covering can withstand at least 200°F (93°C).

■ Use an insulated pad or ¼" (0.64 cm) plywood under range if

installing range over carpeting.

IMPORTANT: To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage. This oven has been designed in accordance with the requirements of UL and CSA International and complies with the maximum allowable wood cabinet temperatures of 194°F (90°C).

Mobile Home - Additional Installation Requirements

The installation of this range must conform to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD Part 280). When such standard is not applicable, use the Standard for Manufactured Home Installations, ANSI A225.1/NFPA 501A or with local codes.

Mobile home installations require:

■When this range is installed in a mobile home, it must be secured to the floor during transit. Any method of securing the range is adequate as long as it conforms to the standards listed above.

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Installation Instructions 20 50.8 CM Freestanding GAS Range Range Safety Your safety and the safety of others are very importantAnti-Tip Bracket Range Foot Tools and Parts Installation RequirementsLocation Requirements Product Dimensions Cabinet Dimensions Freestanding Range Must extend beyond cabinet fronts by ½ 1.3 cm minimumElectrical Requirements Gas Supply RequirementsType of Gas Gas Supply LineGas Pressure Regulator Gas Supply Pressure TestingBurner Input Requirements Installation Instructions Install Anti-Tip BracketUnpack Range Floor MountingMake Gas Connection Typical rigid pipe connectionTypical flexible connection Complete ConnectionVerify Anti-Tip Bracket Is Installed Engaged Initial lighting and gas flame adjustmentsLevel Range Electronic Ignition SystemIf the low flame needs adjusting If the flame needs adjustingCheck Operation of Cooktop Burners Check Operation of Oven/Broil BurnerComplete Installation If you need Assistance or ServiceGAS Conversions LP Gas ConversionTo Convert Surface Burners Natural Gas Conversion Complete ConversionTo Convert Oven Burner Turn the cap over so that N or NAT is visible W10459123B

W10459123B specifications

The Whirlpool W10459123B is a sophisticated and versatile appliance designed to enhance the cooking experience in the modern kitchen. This appliance marries convenience with innovative technology, making it a great addition for both experienced chefs and novices alike.

One of the main features of the W10459123B is its intuitive control panel. Equipped with user-friendly buttons and a digital display, this appliance allows for easy navigation through various cooking settings. Whether you're baking, broiling, or roasting, users can effortlessly adjust temperature and cooking time to achieve desired results.

The W10459123B is also designed with a spacious interior, allowing for larger dishes and multiple servings at once. This is especially useful for families or individuals who enjoy entertaining guests. The even cooking technology ensures that heat is distributed uniformly throughout the cavity, minimizing the chances of hot or cold spots.

Energy efficiency is another highlight of the W10459123B. The appliance incorporates advanced insulation and sensor technology, enabling it to maintain optimal cooking temperatures while using minimal energy. This feature not only helps reduce monthly utility bills but also makes it an environmentally friendly choice for consumers looking to decrease their carbon footprint.

Additional features include a self-cleaning function, which saves time and effort when it comes to maintenance. Users can simply select the self-clean option, and the appliance will take care of the rest, breaking down food residues and spills with minimal manual intervention.

Safety is a top priority with the W10459123B, which includes features like a child lock function to prevent unintended use. The appliance is built with high-quality materials, ensuring durability and longevity, making it a worthwhile investment for any kitchen.

Overall, the Whirlpool W10459123B is a well-rounded appliance that combines functionality, technology, and convenience. Its impressive features and practicality make it an excellent choice for anyone looking to elevate their cooking experience, whether for everyday meals or special occasions. With this appliance in your kitchen, you can enjoy the benefits of advanced cooking technology while achieving delicious results every time.
Top Page Image Contents