Whirlpool SF378PEW warranty Cleaning chart, Part What to USE, HOW to Clean

Page 28

6. After cleaning the gas tube opening and

ports, replace the burner cap and burnerLocating pegs grate. To replace burner cap, make

sure cap is properly aligned and leveled. Fit locating pegs into the recess in the underside of the cap. The cap must be correctly seated on the burner body for proper operation of the burner.

7.Turn on the burner to determine if it will light. If the burner does not light after cleaning, contact an authorized Whirlpool service technician. Do not service the sealed burner yourself.

Cleaning chart

Use the following table to help you clean your range.

PART

WHAT TO USE

Control knobs

Sponge and warm,

 

soapy water

Control panels Sponge and warm, soapy water

OR

HOW TO CLEAN

l Turn knobs to OFF and pull straight away from control panel.

l Wash, rinse, and dry thoroughly. Do not soak.

l Do not use steel wool or abrasive cleansers. They may damage the finish.

l Replace knobs. Make sure all knobs point to OFF.

l Wash, wipe with clean water, and dry thoroughly.

l Do not use steel wool or abrasive cleansers. They may damage the finish.

Paper towel and spray glass cleaner

Exterior surfaces Sponge and warm, (other than control soapy water panels)

l Do not spray cleaner directly on panel. Apply cleaner to paper towel.

l Wash, wipe with clean water, and dry thoroughly.

l Use nonabrasive, plastic scrubbing pad on heavily soiled areas.

l Do not use abrasive or harsh cleansers. They may damage the finish.

NOTE: Do not allow foods containing acids (such as vinegar, tomato, or lemon juice) to remain on surface. Acids may remove the glossy finish. Also wipe up milk or egg spills when cooktop is cool.

Image 28
Contents UseAndCare Table of Contents 800-253-1 301 Thank you for buying a Whirlpool@ appliancePlease record your model’s information Our Consumer Assistance CenterRange Safety Your safety is important to usSee Installation Instructions ALL Ranges can TIPGeneral When using the cooktop When using the ovenCare and cleaning GreaseRead and Save These Instructions Getting to Know Your Range PanelUsing Your Range Using the surface burnersBurner heat settings Surface burner markersCookware tips Case of a prolonged power failureRecommended USE Positioning racks PansHome canning information Food RackFor best air circulation Extra oven rack position roasting rackSetting the clock Using the Minute limerBaking/roasting Broiling Adjusting the oven temperatureControl Broiling tips Position chart Energy saving tipsBroiling rack FoodUsing the automatic MEALTIMER’ clock To delay start and stop automaticallyTo start baking/roasting now and stop automatically Oven vent Storage drawerAnti-tip brackets To verify the anti-tip brackets is engagedHow the cycle works Using the Self-Cleaning CycleBefore you start Setting the controls To stop the Self-Cleaning cycle at any time Special TipsRange Caring for YourSutface burner grates Cleaning Contoured Well Areas Surface burners and cooktopCleaning the surface burners HOW to Clean Cleaning chartPart What to USE Part Oven light To replace the oven lightIf You Need Assistance or Service Before calling for assistanceBurner Fails to Power cord Is not Light Possible Cause If you need service If you need FSP@ Replacement partsIf you are not satisfied with how the problem was solved If you need assistanceGas Range Warranty Length of Warranty Whirlpool will PAY for Full ONE-YEARWarranty Whirlpool will not PAY for