Whirlpool SF378PEW warranty Burner Fails to Power cord Is not Light

Page 32

PROBLEM		POSSIBLE			CAUSE
Burner	fails to	The power cord			is not
light		plugged	into	a live circuit with
		proper	voltage.
		A household fuse has blown
		or a circuit breaker has
		tripped.
		Burner	ports	are	clogged.
Burner	flames	Burner	ports	are clogged.
are uneven

Burner flames Air/gas mixture is incorrect. lift off ports, are

yellow, or are noisy when turned off

Burner		makes	Burner	is wet	from washing.
popping		noise
when	on
Control		knob(s)	You are	not pushing		in before
will not		turn	turning.
Self-Cleaning			The Oven Selector			and Oven
cycle	will not		Temperature		Control are not
operate			set to CLEAN.

The range clock does not show the correct time of day.

The Lock Lever is not in the CLEAN position - all the way to the right.

The Start Time Dial does not show the correct time of day or the knob is not all the way out.

The Stop Time Dial is not set ahead to the time you want the Self-Cleaning cycle to stop.

SOLUTION

Plug the power cord into a live circuit with proper voltage. (See Installation Instructions.)

Replace household fuse or reset circuit breaker. In case of prolonged power failure, manually light burners (see page 10).

Clean with a straight pin (see page 27).

Clean with a straight pin (see page 27). If this fails, call an authorized Whirlpool service technician for service.

Contact an authorized Whirlpool service technician to check air/gas mixture.

Let dry.

Push control knob(s) in before turning to a setting.

Set both the Oven Selector and Oven Temperature Control to CLEAN.

Reset clock to show the correct time of day. (See page 13.)

Move Lock Lever all the way to the right.

Reset the Start Time Knob to show the correct time of day. Pull knob out all the way.

See Step 3 in “Setting the controls” on page 23 for proper setting instructions.

32

Image 32

Contents UseAndCare Table of Contents 800-253-1 301 Thank you for buying a Whirlpool@ appliancePlease record your model’s information Our Consumer Assistance CenterRange Safety Your safety is important to usSee Installation Instructions ALL Ranges can TIPGeneral When using the cooktop When using the ovenCare and cleaning GreaseRead and Save These Instructions Getting to Know Your Range PanelUsing Your Range Using the surface burnersBurner heat settings Surface burner markersRecommended USE Case of a prolonged power failureCookware tips Positioning racks PansHome canning information Food RackFor best air circulation Extra oven rack position roasting rackSetting the clock Using the Minute limerBaking/roasting Control Adjusting the oven temperatureBroiling Broiling tips Position chart Energy saving tipsBroiling rack FoodUsing the automatic MEALTIMER’ clock To delay start and stop automaticallyTo start baking/roasting now and stop automatically Oven vent Storage drawerAnti-tip brackets To verify the anti-tip brackets is engagedBefore you start Using the Self-Cleaning CycleHow the cycle works Setting the controls To stop the Self-Cleaning cycle at any time Special TipsSutface burner grates Caring for YourRange Cleaning Contoured Well Areas Surface burners and cooktopCleaning the surface burners Part What to USE Cleaning chartHOW to Clean Part Oven light To replace the oven lightIf You Need Assistance or Service Before calling for assistanceBurner Fails to Power cord Is not Light Possible Cause If you need service If you need FSP@ Replacement partsIf you are not satisfied with how the problem was solved If you need assistanceGas Range Warranty Length of Warranty Whirlpool will PAY for Full ONE-YEARWarranty Whirlpool will not PAY for