Whirlpool SF365BEXN0 manual Cleaning Removing Burners

Page 20

Cleaning	Cleaning	and Removing Burners
Cleaning	The burners	should bc routinely removed and cleaned. Always	clean the
(Continued)	burners al‘ter ;I spillover. Keepin,(7the burners clean will prevent		improper
	Ignition and an uneven flame.

To remove burners:

Figure I - Two screw4 hold each burner pair in place to keep them from moving around during shipment. Remove and discard shipping screws. Lift burners up and out. This separates them from the mounting bracket under each burner pair.

		To remove burned-on food:
		Soak the bul-ners in a vinegar and water solution for 20 to 30 minutes. For
		stubborn stains. scrub with soap and water or a mild abrasive cleanser and a
		damp cloth. Do not put burners in dishwasher.
		Place burner4 in a warm oven for 30 minute5 to dry. Make sure burners are
		thoroughly dried before replacing them on cooktop.
1	]	To replace burners:
Figure	1	Figure 1 - Place each burner pair in range. Make sure burners are properly
Figure	1	seated on mounting bracket and are level.
		seated on mounting bracket and are level.

Image 20

Contents Self-Cleaning Oven Adjusting 1Properly maintaining the rangeImportant Safety Notice Important Safeguards Erty damageImportant Safeguards Do not cover the insert with foil. Exposed fat could igniteSavetheseinstructions Surface Cooking Oven CookingSetting The Controls Surface CookingFlame Size Cooking UtensilsCharacteristics Excellcn~ conductor Heat. Available Material AluminumRclati\,el poor- heat Chipping. Do not useFluorescent Light Some Models Oven Light Some ModelsClock and Minute Timer Using The OvenSetting Oven Controls Timed Bake Oven Vent Arranging Oven RacksAir circulation in the oven and food baking results Into placeBaking Hints BakingSelecting Bakeware 3aking Problems CausesCorrections Oven too hot incorrect pan size pan not ccntcred in ovenBraising Roasting BraisingHints Broiling BroilingBroiling Hints FIRE. Flour may be explosiveControl Knobs CleaningGeneral Cleaning, Outside Cleaning Removing Burners Removing Oven Door What to Expect During Cleaning Self-Cleaning InstructionsPrecleaning To Clean Do not try to move the latch lever when the loch light i\‘ol 300 pm. or SOOp.mExcess Smoke Stopping a Self-Clean CycleWhen the Self-Clean Cycle is Completed Adjusting Oven Temperature Anti-Tip Bracket Installation Imons Anti-Tip Bracket Installation InstructionsIf You Need Service Or Assistance Before calling for assistanceAre the pans the size called for in the recipe? Director of Consumer Relations Whirlpool CorporationIf you need service Page Page Page WHIRLPOOL@

Cleaning

Cleaning

and Removing Burners

Ignition and an uneven flame.

To remove burners:

Figure I - Two screw4 hold each burner pair in place to keep them from moving around during shipment. Remove and discard shipping screws. Lift burners up and out. This separates them from the mounting bracket under each burner pair.

To remove burned-on food:

Figure 1 - Place each burner pair in range. Make sure burners are properly