Caring For Your Range
Continued
Do not hand clean seal
Hand clean door around edge
Using the Self-Cleaning cycle
The
Before you start
1.Clean the areas shown by hand. They do not get hot enough during the
l The inside of the door. (The center area of the door does not need to be hand cleaned.)
l The frame around the oven.
Do not clean, move or bend the fiberglass seal. Poor cleaning and poor baking will result.
2.Remove the broiler pan and any pots and pans you may have stored in the oven.
NOTE: The broiler pan (without grid) can be cleaned in the oven only if most of the soil has been removed by
3.Wipe out any loose soil or grease. This will
help reduce smoke during the Self-Cleaning
cycle.
4.If you want the oven racks to remain shiny, remove from the oven and clean them by hand. Otherwise, put oven racks on second and fourth guides (guides are counted from bottom to top). After racks are cleaned in the Self- Cleaning cycle, they become harder to slide. See page 27.
5.If you want to clean the reflector bowls in the oven :
l Wipe the reflector bowls of loose soil and grease.
l Place 2 bowls upside down on each oven rack.
For best results, they should not touch each other or the oven walls.
lChrome trim rings must not be cleaned in the oven. They will discolor.
Turn on a vent hood or other kitchen vent during the
20