Whirlpool FGS395Y important safety instructions Lift-up cooktop, Surface burners

Page 28

Lift-up cooktop

1.Remove surface burner grates and reflector pans.

2.Lift front of cooktop at both front corners until the support rods lock into place.

l

l

Personal Injury and

Product Damage Hazard

Be sure both support rods are fully extended and in the locked position. Failure to do so could result in personal injury from the cooktop accidentally falling.

Do not drop the cooktop. Damage can result to the porcelain and the cooktop frame.

3.Wipe with warm, soapy water. Use a soapy steel-wool pad on heavily soiled areas.

4.To lower the cooktop, lift cooktop from both sides while pressing the support rods back to unlock them. Lower the cooktop into place.

Replace reflector pans and surface burner grates.

Surface burners

1.Lift up the cooktop, following the instructions above.

2.Before cleaning, remove screws that hold each of the burners in place. The screws prevent the burners from moving during shipment. Remove the shipping screws with a Phillips screwdriver and lift the burners up and out. This separates the burners from the mounting bracket under each burner pair.

3.Wipe off surface burners with warm, soapy water and a sponge after each use. To remove cooked-on food, soak the burners in a vinegar and water solution for 20-30 minutes. Scrub with a plastic scrubbing pad.

4.If ports are clogged, clean with a straight pin. DO NOT enlarge or distort the ports. DO NOT use a toothpick to clean the ports.

Screws

28

Page 27 Page 29
Image 28
Page 27 Page 29
Contents UseAndCare Your safety is important to us Thank you for buying a Roper applianceImportant Safety Instructions GeneralWhen using the cooktop Care and cleaning When using the ovenGrease Parts And Features Control panelUsing the surface burners Burner heat settingsYour This SectionCase of a prolonged power failure Cookware tipsHome canning information USEPositioning racks Pans6th oven rack position Roasting rack FoodFor best air circulation Command buttons Electronic oven controlDisplay/clock Timehemp set knobSetting the clock Audible signalsUsing the Cancel button Using the electronic TimerTo cancel the Timer Baking/roasting Adjusting the oven temperature ControlBroiling Broiling tipsBroiling Chart Using the electronic Mealtimer clock To delay start and stop automaticallyTo start baking/roasting now and stop automatically To cancel delayed time oven settings during operation Oven vent Energy saving tipsStorage drawer Anti-tip bracketHow the cycle works Using The Self-Cleaning CycleBefore you start Setting the controls To start cleaning immediately24ay .. the start using Stop Additional Self-Cleaning informationSpecial tips To stop the Self-Cleaning cycle at any timeForce IT.I Caring For Your Range Surface burner grates and reflector pansLift-up cooktop Surface burnersHOW to Clean Cleaning chartPart What to USE Part What Oven light To replace the oven lightIf You Need Assistance Or Service ProblemSolution Before calling for assistanceProblem Possible Cause If you need service Atte Problem WasIf you need assistance If you Are not satisfiedPage Length of Warranty What WE will PAY for Gas Cooking Product WarrantyWhat WE will not PAY for
Top Page Image Contents