Cornelius UC 701 service manual Specification Chart

Page 7

Table 1. Design Data (cont’d)

Water Supply–Water inlet fitting is 1/4–inch SAE flare located at the top front of the Unit. The Unit is designed

to	operate on water pressure between 10 PSI and 90 PSI.


Drain Overflow Line (Located at rear of the Unit)		3/8–inch Flexible Tubing


Ambient Operating Temperature		40° F to 100° F


Electrical:

	Unit Electrical Rating	208/230 VAC, 60 Hz, 11.3 Amps,
		Single Phase

	Recommended Electrical Supply	208/230 VAC, 60 hz, 20 Amps
		Dedicated 3–Wire
		Grounded Circuit

		SPECIFICATION CHART
Models	Condensing	VAC		HZ	PH	Wire	Comp.		Fan	GRMTR	Refrigerant		Circuit
	Unit							RLA	Amps	Amps	Oz.	Type	Fuse
UC701–A	Air Cooled	208/230		60	1	2		7.7	1.6	2	13	R404A	20
UC701–W	Water Cooled	208/230		60	1	2		7.7	N/A	2	13	R404A	20
				UC700			650
							650
	hr.						600	hr.
	hr.						500	hr.
	Lbs./24						500	Lbs./24
							550
	Capacity						450	Capacity
							400
							350
		90	80	70	60	50
			Water Temperature Deg. F
			–50	–70	–90	–100
			Air Temperature Deg. F

630460150

4

Image 7

Contents UC 701 Series CONTINUOUS-FLOW Icemaker Table of Contents Table of Contents cont’d Follow Safety Instructions Safety InformationRecognize Safety Information Understand Signal WordsThis page Left Blank Intentionally Claims Instructions General DescriptionTo the User of this Manual DescriptionSpecification Chart Clearance Requirements This page Left Blank Intentionally PRE-INSTALLATION InstallationSide Bracket Installation InstallationIcemaker Float Assembly Initial Start UP, Checks and Adjustment InstructionsThis page Left Blank Intentionally Monthly Guide to ServiceIcemaker Cleaning and Sanitizing Procedures MaintenancePurpose Water Level ControlSemi-Annually How Water Level Control WorksTo Replace Water Level Control Refrigeration System AdjustmentsTo Replace Water Level Safety Switch Refrigeration SystemExpansion Valve Adjustment and TroubleshootingCondenser Modulating Valve BIN Control Condenser Modulating Valve RemovalMotor Check GearmotorStart Relay To Replace Gearmotor AssemblyAuger and Extruding Head Removal Upper NUT and Bearing AssemblyTo Replace Bearing Capacitor Check Electrical CheckoutGear Motor Overload Safety ControlsGuide to Good ICE Wiring Diagram Troubleshooting Chart Icemaker not Operating Troubleshooting Compressors TroubleshootingIMI Cornelius Certificate of WarrantyThis page Left Blank Intentionally IMI Cornelius INC