RADIO RECEPTION
K==3
1 PressTUNER/BAND to select the FM or AM band.
When TUNER/BAND is pressed while the power is off, the power is turned on directly (Direct Play Function).
To select a band with the remote control
Press BAND while pressing SHIFT.
2 Press 4 DOWN or -UP to select a station.
Each time the button is pressed, the frequency changes. When a station is received, “TUNE”is displayed for 2 seconds. During FM stereo reception, [{[~)1) is displayed.
[[mm])
To search for a station quickly (Auto Search)
Keep 44 DOWN or
●The Auto Search may not stop at stations with very weak signals.
When an FM stereo broadcast contains noise
Press MONO TUNER on the remote control while pressing SHIFT so that “MONO”appears on the display.
Noise is reduced, although reception is monaural.
MONO
To restore stereo reception, press MONO TUNER on the remote control while pressing SHIFT so that “STEREO”appears.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the tuning interval.
Press POWER while pressing - on the unit. To reset the interval, repeat this procedure.
m
When the AM tuning interval is changed, all preset stations are cleared. The preset stations have to be set again.
■ | “ | . |
CLEAR | ~ “. | |
PRESETF |
The unit can store a total of 32 preset stations. When a station is stored, a preset number is assigned to the station. Use the preset number to tune in to a preset station directly.
1 Press TUNER/BAND to select a band, and press
a DOWN or
2Press 1I SET to store the station.
A preset number beginning from 1 in consecutive order lor each band is assigned to the station.
Preset number
I
3 Repeat steps 1 and 2.
No more stations will be stored if a total of 32 preset :staticms have already been stored.
m
“FULL”is displayed if you attempt to store more than 32 pKXW stations.
PRESET NUMBER TUNING
Use the remote control to select the preset number directly,
7 Press BAND while pressing SHIFT to sedeclt a band.
2Press numbered buttons
Example:
To select preset number 20, press +10, +10 and O. To select preset number 15, press +10 and 5.
Selecting a preset number on the main unit
Press TUNER/BAND to select a band. Then, press
Each time
To clear a preset station
Select the preset number of the station to be cleared with the numbered buttons. Then, press ■CLEAR, and press II SET within 4 seconds.
The preset numbers of all other stations in the band with higher numbers are decreased by one.