Subwoofer On or Off mode

If you connect a subwoofer to this unit, change the Subwoofer mode to "S-W ON". Low-frequency effect signals are sent to the subwoofer. In "S-W OFF", low-frequency effect signals are directed to the other speakers.

1Play the Dolby Surround sound.

2 Press MANUAL SELECT on the remote control.

"S-W OFF" or "S-W ON" is displayed.

3Press f to display "S-W OFF" or g to display "S-W ON" to select the desired mode.

•Subwoofer mode setting is common to Dolby Digital and Dolby Pro Logic.

Adjustments

Speaker level adjustment

The unit is equipped with a built-in test signal generator for easy balance adjustment of the channels. The test signal "travels" from channel to channel. Adjust the sound level for the same apparent loudness from each channel at listening position.

The left and right front speakers create the stereo effect.

The center speaker helps achieve precise sound positioning over a broad sound field.

The surround speakers enhance the "depth" of the sound field.

1Press NORMAL, PHANTOM or 3 STEREO to select the mode for the speaker configuration (see "Dolby Surround modes").

On the remote control, press SURROUND repeatedly.

-For playback with the supplied speakers, select "NORMAL".

2Hold down MANUAL SELECT on the remote control until "L" flashes in the display.

The indication for the currently adjustable channel flashes in the display and the test signal automatically cycles through the following channels:

-L: The left front speaker

-C: The center speaker

-R: The right front speaker

-RS: The right surround speaker

-LS: The left surround speaker

3Press f or g on the remote control to adjust the sound level.

-For the left and right front speakers: Press fto shift the balance to the left and gto shift to the right.

-For the center and the surround speakers: Press f to de-emphasize the channel and g to emphasize the channel.

•The channel will not change while you are adjusting the sound level.

•Speaker level adjustment is available only for speakers that are activated.

•Adjustment of speaker levels is common to Dolby Digital and Dolby Pro Logic.

•A clicking sound might be heard with the test signal during level adjustment. This is due to the circuit characteristics and is not a malfunction.

To stop speaker level adjustment

Press s.

To adjust the speaker level without the test signal 1 Play the Dolby Surround sound.

2Press NORMAL, PHANTOM or 3 STEREO to select the mode for the speaker configuration.

On the remote control, press SURROUND repeatedly.

3Press MANUAL SELECT repeatedly on the remote control until "L/R" is displayed.

4Press for gto adjust the sound level of the front speakers.

5Repeat steps 3 and 4 to adjust the sound level of the other speakers.

To adjust the center speaker level directly on the remote control

1 Play the Dolby Surround sound.

2Press SURROUND repeatedly to select "NORMAL" or "3 STEREO".

3Press CENTER LEVEL +or -.

To adjust the rear (surround) speaker level directly on the remote control

1 Play the Dolby Surround sound.

2 Press SURROUND repeatedly to select "NORMAL" or "PHANTOM".

3 Press REAR LEVEL +or -.