1 Connect the speaker cords to the front speakers, |
surround speakers and center speaker. |
For the front speakers (marked "FRONT"), connect the ends |
of the stripe cords to the 0terminal and the ends of the |
other cords to the 9 terminal with the front speakers |
cords (without a plug, approx. 4 m / 13.1 ft. ). |
For the surround speakers (marked "REAR"), connect the |
ends of the stripe cords to the 0terminal and the ends |
of the other cords to the 9terminal with the surround |
speaker cords (with plugs, approx. 8 m /26.2 ft.). |
For the center speaker (marked "CENTER"), connect the |
end of the stripe cord to the 0 terminal and the end of |
the other cord to the 9terminal with the center speaker |
cord (with a plug, approx. 3 m / 9.8 ft.). |
2 Connect the front speakers. |
FM antenna
4 Connect the center speaker.
Connect the center speaker cord to the CENTER SPEAKER jack.
AM antenna
En
Connect the right front speaker to the FRONT SPEAKERS |
R terminals and the left to the FRONT SPEAKERS L |
terminals. The speaker cords with the white stripes go to |
the 0terminals. |
3Connect the surround speakers.
Connect each surround speaker cord to the SURROUND SPEAKERS R jack or the SURROUND SPEAKERS L jack.
5Connect the subwoofer.
Connect the subwoofer cord to the SUB WOOFER jack.
•Refer to the Operating Instructions of
6Connect the supplied antennas.
Connect the FM antenna to the FM 75 Ω terminals and the AM antenna to the AM LOOP terminals.
7Connect the video equipment (DVD player, LD player, video tape player, etc.).
If the video equipment has an OPTICAL OUT jack; Remove the dust cap a from the DIGITAL IN (PCM/ DOLBY DIGITAL) OPTICAL (VIDEO) jack of this unit. Then, connect the OPTICAL OUT jack to the DIGITAL IN (PCM/ DOLBY DIGITAL) OPTICAL (VIDEO) jack with an optional optical connecting cord.
Tip:
To activate the spectrum analyzer, connect the digital equipment also by analog connection to the VIDEO/AUX jacks (see below).
5