If the video equipment does not have a digital out jack; Connect the AUDIO OUT jacks of the video equipment to the VIDEO/AUX jacks of this unit with an optional audio connecting cord with RCA phono plugs (red plug to the R jack, white plug to the L jack).
•When connecting an LD player via its AC-3 RF OUT
jack, use an RF demodulator to separate the analog En visual signals and the digital audio signals. Refer to the
Operating Instructions of the LD player.
8 | Connect the television to the video equipment. |
| Refer to the Operating Instructions of the connected |
| equipment for details. |
9 | Connect the AC power cord to an AC outlet. |
| When the AC power cord is connected to an AC outlet for |
| the first time, DEMO appears on the display. |
Positioning the speakers
To achieve the optimum effects obtainable with the Dolby Digital or the Dolby Pro Logic system, it is important to position the speakers properly. Refer to the following illustration to find out the best location in your room.
To mount the surround speakers on the wall Mount each speaker on a spot that can hold its weight.
AIWA disclaims any responsibility for injury to persons or other accidents caused by not fitting the surround speakers properly or if the place of the installation is not suitable.
To deactivate the DEMO, press DEMO/ECO. |
•Do not short-circuit the 0and 9speaker cord leads.
•Do not leave objects generating magnetism or objects affected by magnetism near the speakers.
Note on positioning
Allow 10 cm (4 in.) clearance from the top of the unit for the Window movement when you position the unit.
L&R: Front speakers
C: Center speaker
Position in the center of the two front speakers. In addition, position on or below the TV set, if connecting a TV set to the unit.
LS&RS: Surround speakers
Place the surround speakers directly to the side of or slightly behind the listening area. Align them horizontally, about 1 meter (3.2 feet) above ear height.
SW: Subwoofer
Place the subwoofer on the floor close to a wall or in a corner of the room.
•Sound output from the center and the surround speakers is only available when the Dolby Digital system or the Dolby Pro Logic system is activated with the appropriate setting.
Remote control
Detach the battery compartment lid at the rear of the remote control and insert two R6 (size AA) batteries with correct polarity.
•Replace the batteries with new ones when the operational distance between the remote control and main unit becomes shorter.
•Remove the batteries if the unit is not going to be used for an extended period of time.
•The remote control may not operate if it is used under intense sunlight, etc., or if its line of sight is obstructed.
6