EdgeStar IB450SS owner manual Exterior Cleaning, Interior Cleaning

Page 19
Exterior Cleaning

There are 5 things to keep clean:

1.The exterior.

2.The interior.

3.The condenser

4.Water distribution tube

5.The ice-making system

Exterior Cleaning

The door and cabinet may be cleaned with a mild detergent and warm water solution such as 1 oz of dishwashing liquid mixed with 2 gallons of warm water. Do not use solvent based or abrasive cleaners. Use a soft sponge and rinse with clean water. Wipe with a soft clean towel to prevent water spotting. If the door panel is stainless steel, it can discolor when exposed to chlorine gas and moisture. Clean stainless steel with a cloth dampened with a mild detergent and warm water solution. Never use an abrasive cleaning agent.

Interior Cleaning

The ice storage bin should be sanitized occasionally. Clean the water trough before the ice maker is used for the first time and reused after stopping for an extended period of time. It is usually convenient to sanitize the trough after the ice making system has been cleaned and the ice storage bin is empty.

1.Disconnect power to the unit.

2.Open the door and take out the removable storage bin. With a clean cloth, wipe down the interior of the unit with a sanitizing solution made of 1 ounce of household bleach and

2gallons of hot water (95º to 115ºF).

3.Rinse thoroughly with clean water.

4.Put the cleaned and empty ice storage bin back inside the unit.

5.Reconnect power to the unit.

The ice scoop should be washed regularly. Wash it just like any other utensil.

DO NOT use solvent-based cleaning agents or abrasives on the interior. These cleaners may transmit taste to the ice cubes, or damage or discolor the interior19.

Image 19
Contents IB450SS Clear Ice Maker use, and maintenanceBe sure to stand the ice maker upright for at least 24 hours Installation only by a licensed plumberClear Ice Maker User’s ManualFor Your Records Page ICE MAKER SAFETY………………………………………………………………… TABLE OF CONTENTSYour safety and the safety of others are very important ICE MAKER SAFETYIMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFEGUARDS Extension Cord Power consumptionUnit weight Ice cube dimensionsNote on ice storage COMPONENT LOCATIONSUnpacking ICE MAKER INSTALLATIONExcessive Weight Hazard Remove tape and glue from your icemaker before usingz This icemaker should be installed by a licensed plumber only Cleaning before useLocation Requirements Never use an extension cord Electrical RequirementsElectrical Shock Hazard Plug into a grounded 3-prong outlet Never remove the grounding prong from the plug. Never use an adapterLeveling the Ice Maker IMPORTANT Before you begin, unplug the ice maker or disconnect powerReversing the Door Swing Recommended grounding methodTo remove door from hinges Water Supply ConnectionsTo replace door on hinges Drain Installation TypesConnecting the water line Free-standing installationFinal Check List before Operation Recessed installationBuilt-in installation OPERATIONHow the machine Makes Ice Never turn the water supply tap off when the ice maker is workingNever touch the evaporator when the machine is running Operating MethodNormal Sounds How the machine uses the waterPreparing the Icemaker for Long Storage CLEANING AND MAINTENANCEDo not touch the power plug when your hands are wet What should be kept cleanInterior Cleaning Exterior CleaningWater Distribution Tube cleaning Condenser CleaningIce-making system Cleaning Control Panel rear of unit Descriptions of LEDs and buttons Do not let water contact the control box TROUBLESHOOTINGBefore Calling for Service Major FunctionsPossible Cause ProblemProbable Correction Plug the ice maker in. Replace fuse DESCRIPTION OF WARRANTY SERVICE LIMITED WARRANTYWHAT IS COVERED WHAT IS NOT COVEREDPage EdgeStar Products Box Austin, TX Toll Free