EdgeStar IB450SS Operating Method, Never touch the evaporator when the machine is running

Page 16

Operating Method

11. Have you checked for leaks at all water supply connections- and at the drain?

Operating Method

1.Turn on the water tap, let the water trough fill, then switch the ICE/OFF/WASH switch on the front panel to the ICE position. The ice maker will start working automatically.

2.After three minutes, the machine will automatically go to the ice making stage, and the sound of flowing water will be heard.

3.When the batch of ice has been fully formed, ice will automatically be harvested to the ice storage bin.

4.When the ice storage bin is full, the sheet of cubes will not fall completely and will hold the ice-full probe open. The machine stops making ice and automatically progresses to the cold preservation stage. During this stage, the compressor works regularly to keep the temperature lower to reduce ice melting.

5.The unit will start making ice again after the ice cubes are removed. At that time, the ice-full probe swings back to operating position.

IMPORTANT:

•Although the unit has been tested and cleaned at the factory, due to long-term transit and storage, the first batch of cubes must be discarded.

•Never turn the water supply tap off when the ice maker is working.

•Never touch the evaporator when the machine is running.

•Except to take ice from the unit, keep the door closed to reduce melting and insure proper ice formation.

How the machine Makes Ice

Turn the ICE/OFF/WASH switch to the ICE position. The machine will automatically start the ice making stage.

16

Image 16

Contents use, and maintenance IB450SS Clear Ice MakerInstallation only by a licensed plumber Clear Ice MakerUser’s Manual Be sure to stand the ice maker upright for at least 24 hoursFor Your Records TABLE OF CONTENTS Page ICE MAKER SAFETY…………………………………………………………………Your safety and the safety of others are very important ICE MAKER SAFETYIMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFEGUARDS Power consumption Unit weightIce cube dimensions Extension CordCOMPONENT LOCATIONS Note on ice storageICE MAKER INSTALLATION Excessive Weight HazardRemove tape and glue from your icemaker before using Unpackingz This icemaker should be installed by a licensed plumber only Cleaning before useLocation Requirements Electrical Requirements Electrical Shock Hazard Plug into a grounded 3-prong outletNever remove the grounding prong from the plug. Never use an adapter Never use an extension cordIMPORTANT Before you begin, unplug the ice maker or disconnect power Reversing the Door SwingRecommended grounding method Leveling the Ice MakerTo remove door from hinges Water Supply ConnectionsTo replace door on hinges Installation Types Connecting the water lineFree-standing installation DrainRecessed installation Built-in installationOPERATION Final Check List before OperationNever turn the water supply tap off when the ice maker is working Never touch the evaporator when the machine is runningOperating Method How the machine Makes IceHow the machine uses the water Normal SoundsCLEANING AND MAINTENANCE Do not touch the power plug when your hands are wetWhat should be kept clean Preparing the Icemaker for Long StorageExterior Cleaning Interior CleaningWater Distribution Tube cleaning Condenser CleaningIce-making system Cleaning Control Panel rear of unit Descriptions of LEDs and buttons TROUBLESHOOTING Before Calling for ServiceMajor Functions Do not let water contact the control boxPossible Cause ProblemProbable Correction Plug the ice maker in. Replace fuse LIMITED WARRANTY WHAT IS COVEREDWHAT IS NOT COVERED DESCRIPTION OF WARRANTY SERVICEPage EdgeStar Products Box Austin, TX Toll Free