IMPORTANT SAFEGUARDS
Before the ice maker is used, it must be properly positioned and installed as described in this manual, so read the manual carefully. To reduce the risk of fire, electrical shock or injury when using the ice maker, follow basic precautions, including the following:
zPlug into properly grounded outlet, do not use an adapter, and do not use an extension cord.
zIt is recommended that a separate circuit, serving only your ice maker, be provided. Use receptacles that cannot be turned off by a switch or pull chain.
zDo not connect or disconnect the electric plug when your hands are wet.
zNever clean ice maker parts with flammable fluids. These fumes can create a fire hazard or explosion. And do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. The fumes can create a fire hazard or explosion.
zBefore proceeding with cleaning and maintenance operations, make sure the power line of the unit is disconnected and the water line is shut off
zReplace all panels before operating after servicing or maintenance.
zUnplug the ice maker or disconnect power before cleaning or servicing. Failure to do so can result in electrical shock or death.
zDo not attempt to repair or replace any part of your ice maker unless it is specifically recommended in this manual. All other servicing should be referred to a qualified technician.
zUse two or more people to move and install ice maker. Failure to do so can result in a back injury or other injury.
zTo ensure proper ventilation for your ice maker, Choose a
zThe ice maker should not be located next to ovens, grills or other sources of high heat.
zThe ice maker must be installed with all electrical, water and drain connections in accordance with state and local codes. A standard electrical supply (115 V, 60 Hz,), properly grounded in accordance with the National Electrical Code and local codes and ordinances is required.
zDo not kink or pinch the power supply cord between the ice maker and cabinet.
zThe fuse (or circuit breaker) size should be 3 amp.
zIt is important for the ice maker to be leveled in order to work properly. You may need to make several adjustments to level it.
zAll installations must be in accordance with local plumbing code requirements.
zMake certain that the pipes are not pinched or kinked or damaged during installation.
zCheck for leaks after water line connection.
zNever allow children to operate, play with or crawl inside the ice maker.
zAlthough the unit has been tested at the factory, due to
6