EdgeStar IB450SS Water Supply Connections, To remove door from hinges, To replace door on hinges

Page 13

To remove door from hinges:

1.Using a Phillips screwdriver, remove the screws and take off top hinge. Keep the parts together and set them aside.

3.Lift door off bottom hinge and turn it upside down so that the handle is on the right. Set door aside.

To replace door on hinges:

1.Using a flathead screwdriver, remove the plug buttons from the screw holes opposite the door hinges, top and bottom. Set aside.

2.Remove the bottom hinge, place on the opposite side at the bottom of the door.

3.Position the door on the bottom hinge.

4.Align the door on the bottom hinge and replace the top hinge.

5.Push the plug buttons into the original screw holes. See Figure below.

Water Supply Connections

The water supply should be ready at the point of installation. The water supply pressure should be a minimum of 15 psig with a static pressure not more than 80 psig. (A wall outlet directly behind the ice maker will make installation easier.)

Image 13

Contents IB450SS Clear Ice Maker use, and maintenanceClear Ice Maker Installation only by a licensed plumberUser’s Manual Be sure to stand the ice maker upright for at least 24 hoursFor Your Records Page ICE MAKER SAFETY………………………………………………………………… TABLE OF CONTENTSYour safety and the safety of others are very important ICE MAKER SAFETYIMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFEGUARDS Unit weight Power consumptionIce cube dimensions Extension CordNote on ice storage COMPONENT LOCATIONSExcessive Weight Hazard ICE MAKER INSTALLATIONRemove tape and glue from your icemaker before using Unpackingz This icemaker should be installed by a licensed plumber only Cleaning before useLocation Requirements Electrical Shock Hazard Plug into a grounded 3-prong outlet Electrical RequirementsNever remove the grounding prong from the plug. Never use an adapter Never use an extension cordReversing the Door Swing IMPORTANT Before you begin, unplug the ice maker or disconnect powerRecommended grounding method Leveling the Ice MakerTo remove door from hinges Water Supply ConnectionsTo replace door on hinges Connecting the water line Installation TypesFree-standing installation DrainBuilt-in installation Recessed installationOPERATION Final Check List before OperationNever touch the evaporator when the machine is running Never turn the water supply tap off when the ice maker is workingOperating Method How the machine Makes IceNormal Sounds How the machine uses the waterDo not touch the power plug when your hands are wet CLEANING AND MAINTENANCEWhat should be kept clean Preparing the Icemaker for Long StorageInterior Cleaning Exterior CleaningWater Distribution Tube cleaning Condenser CleaningIce-making system Cleaning Control Panel rear of unit Descriptions of LEDs and buttons Before Calling for Service TROUBLESHOOTINGMajor Functions Do not let water contact the control boxPossible Cause ProblemProbable Correction Plug the ice maker in. Replace fuse WHAT IS COVERED LIMITED WARRANTYWHAT IS NOT COVERED DESCRIPTION OF WARRANTY SERVICEPage EdgeStar Products Box Austin, TX Toll Free