Wisdom Wands SC-1 Front Panel, Power Switch and Indicator, Setup Memory LED Indicators

Page 11

 

Front Panel

1Power Switch and Indicator

The SC-1 features a sculpted front panel that conceals two switches under the flexible ends of the middle section. On the left side, gently pressing the end of the center section will engage a microswitch under the face of the SC-1, which will in turn toggle the unit between operate and standby modes. The international symbol for power is inscribed in this location to designate its purpose.

The amber LED indicator on the left side of the center section is lit when the SC-1 is in standby to indicate that it is receiving power; it is off when the SC-1 is either fully on or when there is no power being supplied to the unit. (When the SC-1 is fully on, one of the setup memory LEDs will be lit to indicate both power and which setup memory is being used. If all the LEDS are off, no power is being supplied to the unit.)

The SC-1 requires several seconds to “boot up” when coming out of stand- by. The amber LED flashes during this startup process, turning off when it is complete. One of the Setup Memory LEDs will turn on at this point to indicate which memory is active).

2Setup Memory LED Indicators

The Wisdom System Controller incorporates the latest version of Audyssey MultEQ® XT room correction to enable it to address room- specific problems that would otherwise compromise performance. Under most circumstances, a single calibration of the system for the room and your preferred listening positions is all that is necessary. But the SC-1 provides storage of up to three complete and independent calibrations to address varioius situations.

11

Image 11
Contents Wisdom Audio System Controller SC-1 Risk of Electric Shock Do not Open Important Safety Instructions Table of Contents Care & Maintenance North American Warranty Unpacking the SC-1 Placement Considerations Operating Voltage Special Design Features System-Specific EQ Front Panel Power Switch and IndicatorSetup Memory LED Indicators Setup Calibration Selector Switch Channel Inputs Rear PanelChannel High Planar Output Channel Subwoofer Output Channel Low Woofer Output12v Trigger In and Out USB PortRS232 Interface AC Mains Input, Switch and Fuse Assembly Page Introduction to Room Acoustics Surround channel geometry Stable, 3-dimensional stereo imagingSmooth, consistent bass Center channel heightSubwoofer Placement Room Treatment Suppliers of Acoustic Treatments Books on AcousticsGetting Ready to Calibrate Before Calibration During Calibration Wisdom System Configuration Speaker Selection Speaker Selection screen High Crossover Volume Trim Sample only 85 90 = Audyssey MultEQ Pro MultEQ Pro Welcome screen Job Information Options/Microphone Selection Room Dimensions Measurement Measuring additional positions Detection Results Page Target Sound Options Disconnect the microphone Save Results Page Calibration Completed Care & Maintenance North American Warranty Obtaining Service Recommended minimum load impedance SpecificationsDimensions Page Is a registered trademark of Wisdom Audio, Inc