Wisdom Wands SC-1 owner manual Setup Calibration Selector Switch

Page 12

These three LEDs indicate which of the three setup memories is currently active. They also serve to indicate that the unit is powered up and operat- ing normally. (When the unit is in standby, only the amber standby LED on the left side of the front panel is lit; the blue memory LEDs are off.)

The LEDs indicate which of the three setup memories is active:

LED 1 on = Setup memory #1 enabled

LED 2 on = Setup memory #2 enabled

LED 3 on = Setup memory #3 enabled

LED 1 blinking slowly = MultEQ® bypassed temporarily

The bypass mode is available so you can hear the difference room correc- tion has made on your system. When the room correction subsystem is bypassed, the active crossover and other system-specific circuitry is still engaged. This allows you to easily hear only what the room correction software is doing for your system.

You can cycle through the available memories and bypass mode by press- ing the Setup Calibration Switch to the right of these indicators. (See 3, below.)

In addition, there is one special case:

During room correction calibration (only), all three LEDs will be on, and the LED for the setup memory you are working on will blink for the duration of the calibration. The LEDs will return to their normal operation as described above once the results of the calibration are saved permanently to memory.

3Setup Calibration Selector Switch

Pressing the right side of the center section of the SC-1 front panel will activate a microswitch that cycles the unit through the available setup memories.

If only one memory has been set up (which is fairly typical), pressing this button will toggle MultEQ XT on and off. If multiple setups have been stored, pressing this button will cycle through the available setups in order, ending in the same bypass mode for the room correction prior to starting the cycle over again:

Setup Memory 1

Setup Memory 2 (if available)

Setup Memory 3 (if available)

Bypass MultEQ® XT

12

Image 12
Contents Wisdom Audio System Controller SC-1 Risk of Electric Shock Do not Open Important Safety Instructions Table of Contents Care & Maintenance North American Warranty Unpacking the SC-1 Placement Considerations Operating Voltage Special Design Features System-Specific EQ Power Switch and Indicator Setup Memory LED IndicatorsFront Panel Setup Calibration Selector Switch Rear Panel Channel InputsChannel High Planar Output Channel Low Woofer Output Channel Subwoofer OutputUSB Port RS232 Interface12v Trigger In and Out AC Mains Input, Switch and Fuse Assembly Page Introduction to Room Acoustics Stable, 3-dimensional stereo imaging Smooth, consistent bassCenter channel height Surround channel geometrySubwoofer Placement Room Treatment Books on Acoustics Suppliers of Acoustic TreatmentsGetting Ready to Calibrate Before Calibration During Calibration Wisdom System Configuration Speaker Selection Speaker Selection screen High Crossover Volume Trim Sample only 85 90 = Audyssey MultEQ Pro MultEQ Pro Welcome screen Job Information Options/Microphone Selection Room Dimensions Measurement Measuring additional positions Detection Results Page Target Sound Options Disconnect the microphone Save Results Page Calibration Completed Care & Maintenance North American Warranty Obtaining Service Specifications Recommended minimum load impedanceDimensions Page Is a registered trademark of Wisdom Audio, Inc