Wisdom Wands SC-1 owner manual Specifications, Recommended minimum load impedance

Page 45

Specifications

All specifications are subject to change at any time, in order to improve the product.

Signal to Noise ratio:

–110 dB (ref 2.5V rms A-wtd.)

Input impedance:

25 kΩ (balanced)

Output impedance:

50 Ω

■ Recommended minimum load impedance:

600 Ω

Maximum output voltage:

2.5V rms

Maximum input voltage:

2.5V rms

Power consumption:

33W

Thermal load:

2 BTU/minute

DC trigger input sensitivity:

3-20V @ 10 mA

DC trigger output signal:

12V @ 100 mA

Mains voltage ranges:

100-120V or 200-240V

Overall dimensions:

See “Dimensions”

Shipping weight:

34 lbs. (15.4 kg)

For more information, see your Wisdom Audio dealer, or contact:

Wisdom Audio

1572 College Parkway, Suite 164

Carson City, NV 89706

www.wisdomaudio.com

information@wisdomaudio.com

Ph: 775.887.8850

Fax: 775.887.8820

45

Image 45
Contents Wisdom Audio System Controller SC-1 Risk of Electric Shock Do not Open Important Safety Instructions Table of Contents Care & Maintenance North American Warranty Unpacking the SC-1 Placement Considerations Operating Voltage Special Design Features System-Specific EQ Power Switch and Indicator Setup Memory LED IndicatorsFront Panel Setup Calibration Selector Switch Channel Inputs Rear PanelChannel High Planar Output Channel Subwoofer Output Channel Low Woofer OutputUSB Port RS232 Interface12v Trigger In and Out AC Mains Input, Switch and Fuse Assembly Page Introduction to Room Acoustics Smooth, consistent bass Stable, 3-dimensional stereo imagingCenter channel height Surround channel geometrySubwoofer Placement Room Treatment Suppliers of Acoustic Treatments Books on AcousticsGetting Ready to Calibrate Before Calibration During Calibration Wisdom System Configuration Speaker Selection Speaker Selection screen High Crossover Volume Trim Sample only 85 90 = Audyssey MultEQ Pro MultEQ Pro Welcome screen Job Information Options/Microphone Selection Room Dimensions Measurement Measuring additional positions Detection Results Page Target Sound Options Disconnect the microphone Save Results Page Calibration Completed Care & Maintenance North American Warranty Obtaining Service Recommended minimum load impedance SpecificationsDimensions Page Is a registered trademark of Wisdom Audio, Inc