Wisdom Wands SC-1 owner manual Risk of Electric Shock Do not Open

Page 2

Danger

Important

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK, DO NOT REMOVE COVER. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying this equipment.

Marking by the “CE” symbol (shown left) indicates compliance of this device with the EMC (Electromagnetic Compatibility) and LVD (Low Voltage Directive) standards of the European Community.

Manufactured under license from Audyssey Laboratories. U.S. and foreign pat- ents pending. Audyssey, Audyssey Labsare trademarks of Audyssey Laboratories. MultEQ® XT is a registered trademark of Audyssey Laboratories.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruc- tions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television recep- tion, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment and the receiver

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

Consult the dealer or an experienced radio/TV technician for help

2

Image 2
Contents Wisdom Audio System Controller SC-1 Risk of Electric Shock Do not Open Important Safety Instructions Table of Contents Care & Maintenance North American Warranty Unpacking the SC-1 Placement Considerations Operating Voltage Special Design Features System-Specific EQ Front Panel Power Switch and IndicatorSetup Memory LED Indicators Setup Calibration Selector Switch Rear Panel Channel InputsChannel High Planar Output Channel Low Woofer Output Channel Subwoofer Output12v Trigger In and Out USB PortRS232 Interface AC Mains Input, Switch and Fuse Assembly Page Introduction to Room Acoustics Center channel height Stable, 3-dimensional stereo imagingSmooth, consistent bass Surround channel geometrySubwoofer Placement Room Treatment Books on Acoustics Suppliers of Acoustic TreatmentsGetting Ready to Calibrate Before Calibration During Calibration Wisdom System Configuration Speaker Selection Speaker Selection screen High Crossover Volume Trim Sample only 85 90 = Audyssey MultEQ Pro MultEQ Pro Welcome screen Job Information Options/Microphone Selection Room Dimensions Measurement Measuring additional positions Detection Results Page Target Sound Options Disconnect the microphone Save Results Page Calibration Completed Care & Maintenance North American Warranty Obtaining Service Specifications Recommended minimum load impedanceDimensions Page Is a registered trademark of Wisdom Audio, Inc