Daewoo frs20 manual Dispenser Model Cled Display of Front PCB, Error Code Contents

4-10-2. Dispenser Model (CLED Display of Front PCB)

INPUT

CONTROL OBJECT

Temperature Control Buttons

88 Display CLED

CONTENTS REMARKS

1.How to start

1)Under “LOCK” mode, press “SUPER FREEZER” button 5 times while pressing “FREEZER SET” button at the same time.

2)The front CLED displays as the right diagram shows

( [Ex.] Time Display of 0003 signifies 3 minutes of power on time.)

3)Press “FREEZER SET” button and the following value is displayed successively.

①Time

② F-Sensor temperature

③ D-Sensor temperature

④ R-Sensor temperature

⑤ RT-Sensor temperature

⑥ P Factor display (Refer to water supply mode of automatic icemaker) ⑦ Filter remaining time until change (First check ; 4,320Hr)

Refer to Filter Information Reset of CLED of front control panel.

4)Error is displayed only if there is any ; it is skipped if no error.

2.How to stop

1)Push “LOCK” button 1 time.

2)It stops automatically in 4 minutes from the start.

3.All the error Codes are reset if they turn to be normal.

4.Error code

ERROR CODE	CONTENTS
F1	F-sensor : disconnection (“Lo”), short (“Hi”)
r1	R-sensor : disconnection (“Lo”), short (“Hi”)
rt	RT-sensor : disconnection (“Lo”), short (“Hi”)
d1	D-sensor : disconnection (“Lo”), short (“Hi”)
dr	R-Door Switch : defective
dF	F-Door Switch : defective
dH	Home bar Door Switch : defective
EI	I-sensor : disconnection (“Lo”), short (“Hi”)
EF	Flow sensor : defective
Et	Horizontal switch : error
Eg	Water supply : error
ES	Micro switch : error
EA	Drop the ice while Et
Eu	Full ice switch : error
C1	Cycle : abnormal or defective
F3	Return after defrosting : abnormal or defective
Co	Display Full Down mode
D2	Display forced defrost mode for A/S

22