3.Remove any substance from filter
1)Open the main tap water valve and check if water comes out of the Water Tube.
2)Check if the Water Valve is open in case water does not come out.
3)Leave the valve open until clean water is coming out.
※Initial water may contain some substances out of filter (manufacturing process).
4. Attach the filter box
1)Screw and fasten the filter holder to the left/right side of the back of refrigerator.
※In case the holder is not fastened well, remove the back paper of the tape on the filter holder and attach it.
2)Insert the filter box into the holder.
5. Connect water tube
1)Remove the rear cover at the bottom back of the refrigerator.
2)Insert the fastening ring into the Water tube.
(Be careful to follow the direction of the nut.)
3)Insert the Water Tube into the top of Water Valve, turn the nut clockwise to fasten it. (The Water valve is to the right of the motor.)
4)Check for any bent tubes or water leaks; if so,
5)Replace the rear cover. (The Water Tube should be placed between the groove of the refrigerator back and motor cover.)
Set the tube upright as the figure shows.
6.Fasten water tube
1)Fasten the Water Tube with the [Fastener A] .
2)Check if the tube is bent or sqeezed. If so, set it right to prevent any water leak.
7.After installation
1)Plug the refrigerator, press the [WATER] button on the control panel for 2~3 minutes to remove any air (bubble) in the pipes and drain out the initial water.
2)Check the water leak again through the water supply system (tubes, connectors and pipes) Rearrange the tubes again and do not move the refrigerator.
83