Installation Instructions - Intergrated Application
Tools You Will
Need
Safety Glasses
FOR YOUR SAFETY:
While performing installations described in this section, gloves, safety glasses or goggles should be worn.
Level |
Gloves |
Flashlight |
Carpenters |
Square |
Measuring Tape |
Drill & Hole Saw set
Preparing the Enclosure
Electrical Requirements:
The appliance must be connected to an individual properly grounded electrical outlet, protected by a 15 or 20 ampere circuit breaker or time delay fuse.
•It is recommended that you do not install the wine cooler into a corner (i.e. directly beside a wall). This is to allow the door(s) to have a greater then 90° opening swing. A limited door swing will prevent the shelves from sliding out as intended, and may lead to damaging the door gasket(s).
•The rough cabinet opening must be on a level floor area and at least 24” deep* by 24” wide. The opening should also have a height of at least
•The electrical outlet may be positioned from within either side of the adjacent cabinetry, or the rear of the shaded area (as shown in Fig C.).
Important: If the electrical outlet is surface mounted (not flush) within the enclosure, the depth requirment for the installation may be affected.
•If the electrical outlet is located inside the adjacent cabinetry, cut a
Fig C
34-1/2”
From
Underside
of
Countertop
to Floor
cabinetry 
24”
2”Min*
Electrical Access
6” 
24” 
Cabinets
Square
and
Plumb
*The listed depth requirment for the installation is assuming that the electrical outlet is located in the
adjacent cabinetry or is flush mounted in the rear wall, not surface mounted in the enclosure.
8