Whirlpool GX2FHDXVB Refrigerator door, Freezer door, Replace Doors and Hinges, Final Steps

Page 7

Refrigerator door

1.Remove the refrigerator handle assembly as shown in Graphic 2. Keep all parts together.

2.Remove door handle seal screw front. Move to opposite side of refrigerator door as shown in Graphic 5.

3.Remove the door stop. Move it to the opposite side of the refrigerator door as shown in Graphic 3.

4.Attach refrigerator handle on opposite side of the refrigerator door with the two screws as shown in Graphic 2. Replace handle trim as shown.

5.Tighten all screws. Set aside the door until hinges and freezer compartment drawer are in place.

Freezer door

1.Remove the freezer handle assembly as shown in Graphic 4. Keep all parts together.

2.Remove door stop. Move to opposite side of freezer door as shown in Graphic 3.

3.Attach handle to opposite side of freezer door.

4.Tighten all screws. Set the door aside.

5.Remove the base grille by grasping the grille firmly with both hands and pulling it toward you.

NOTE: Place a shim under the bottom front edge of the refrigerator cabinet to take the weight off the roller brackets.

6.Remove the screws from both roller brackets. See Graphic 6.

7.Remove the hinge plate located behind the roller bracket and move it to the opposite side of the refrigerator. Move the hinge pin and shim to the outside hole on the hinge plate. See Graphic 6.

Replace Doors and Hinges

Standard Door

NOTE: Graphics may be reversed if door swing is reversed.

Freezer drawer models

1.Replace the parts for the bottom hinge as shown. Tighten screws.

NOTE: Provide additional support for the door while the hinges are being moved. Do not depend on the door gasket magnets to hold the door in place while you are working.

2.Assemble the parts for the top hinge as shown in Top Hinge graphic. Do not tighten screws completely.

3.Adjust the door so that the bottom of the refrigerator door is aligned with the top of the freezer drawer. Tighten all screws.

Freezer door models

1.Make sure the hinge plate is securely fastened behind the roller bracket and that the hinge pin is inserted into the outside hole. Fully tighten all roller bracket screws. See Graphic 6.

2.Remove the shim that you placed under the front edge of the refrigerator cabinet. Replace the freezer door.

NOTE: Provide additional support for the door while the hinges are being moved. Do not depend on the door gasket magnets to hold the door in place while you are working.

3.Assemble the parts for the center hinge as shown in the Center Hinge graphic, and tighten all the screws. Replace the refrigerator door.

4.Assemble the parts for the top hinge as shown in the Top Hinge graphic. Do not tighten the screws completely.

5.Adjust the doors so that the bottom of the refrigerator door is aligned with the top of the freezer door. Tighten all screws.

French Doors

1.Assemble the parts for the top hinges as shown in Top Hinge graphic. Do not tighten the screws completely.

2.Replace the parts for the bottom hinges as shown in Bottom Hinge graphic. Tighten screws. Replace the refrigerator doors.

NOTE: Provide additional support for the refrigerator doors while the hinges are being moved. Do not depend on the door gasket magnets to hold the doors in place while you are working.

3.Align each door so that the bottom of the refrigerator door aligns evenly with the top of the freezer drawer. Tighten all screws.

4.Reconnect the wiring plug on top of the left-hand side refrigerator door.

5.Replace the top hinge covers.

Remove and Replace Freezer Drawer

IMPORTANT:

Two people may be required to remove and replace the freezer drawer.

All graphics are included later in this section after “Final Steps.”

Remove Drawer Front

1.Open the freezer drawer to full extension.

2.Loosen the four screws attaching the drawer glides to the drawer front. See Drawer Front Removal graphic.

NOTE: Loosen screws three to four turns. Keep the screws in the drawer front.

3.Lift drawer front upward and off the screws. See Drawer Front Removal graphic.

Replace Drawer Front

1.Slide the drawer glides out of the freezer compartment. Insert the screws in the top of the drawer front into the slots in the drawer brackets. See Drawer Front Replacement graphic.

2.Pull the drawer brackets toward you to insert the two screws in the bottom of the drawer front into the brackets. See Drawer Front Replacement graphic.

3.Completely tighten the four screws.

Final Steps

1.Check all holes to make sure that hole plugs and screws are in place. Reinstall top hinge cover as shown in Top Hinge graphic.

2.Replace the base grille.

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

3.Plug into a grounded 3 prong outlet.

4.Return all removable door parts to door and food to refrigerator.

7

Image 7
Contents Refrigerator User Instructions Refrigerator SafetyUnpack the Refrigerator Installation InstructionsBefore You Throw Away Your Old Refrigerator or Freezer Recommended Grounding Method Clean Before UsingLocationRequirements Electrical Requirements Tools Needed Water Supply Requirements Connect the Water Supply Reverse Osmosis Water SupplyStyle Refrigerator Doorsand DrawerConnect to Refrigerator French Doors Standard DoorRemove and Replace Freezer Drawer Refrigerator doorFreezer door Replace Doors and HingesStandard Door Freezer Door Door Removal Replacement Door Swing Reversal optionalFront View Side View Door Stop Screws Standard Door Freezer DrawerDoor Removal and Replacement Door Closing and Door Alignment Refrigerator USEOpening and Closing Doors To Turn Off/On Using the ControlsCrisper Humidity Control Ice MakerWater Filtration System CleaningRefrigerator Care Water DispenserRefrigerator Operation TroubleshootingTo Clean Your Refrigerator Changing the Light BulbDoors will not close completely Temperature and MoistureTemperature is too warm Ice and WaterRecently dispensed large amount of water? Allow 24 hours Water dispenser will not operate properlyIs the water pressure at least 35 psi 241 kPa? The water Water from the dispenser is warmApplication Guidelines/Water Supply Parameters Performance Data SheetsModel UKF8001AXX-200 Capacity 200 Gallons 757 Liters Disclaimer of Implied Warranties Limited WarrantyItems Excluded from Warranty This limited warranty does not coverSeguridad DEL Refrigerador Instrucciones Para EL Usuario DEL RefrigeradorCómo quitar los materiales de empaque Instrucciones DE InstalaciónDesempaque el refrigerador Antes de tirar su viejo refrigerador o congeladorRequisitos eléctricos Requisitos de ubicaciónMétodo de conexión a tierra recomendado Herramientas Necesarias Requisitos del suministro de aguaConexión del suministro deagua Suministro de agua por ósmosis inversaConexión al refrigerador EstiloComplete la instalación Puerta estándar Puertas y cajón del refrigeradorDos puertas con congelador en la parte inferior Cómo volver a poner las puertas y las bisagras en su lugar CarcasaPuerta del refrigerador Puerta del congeladorPasos finales Cómo quitar y volver a colocar el cajón del congeladorPara quitar el frente del cajón Para volver a colocar el frente del cajónPuerta estándar-Congelador con puerta Bisagra superiorPuerta estándar-Congelador de cajón Bisagra inferiorDos puertas con congelador en la parte inferior Cómo quitar y volver a poner la puerta en su lugarCómo abrir y cerrar las puertas Cierre y alineamiento de la puertaPara encender/apagar Uso de los controlesControl dehumedad del cajón para verduras Fábrica de hieloCómo despachar agua Despachador de aguaSistema de filtración de agua LimpiezaPara limpiar su refrigerador Solución DE ProblemasCómo cambiar el foco Funcionamiento delrefrigeradorParece que el refrigerador es ruidoso Temperatura y humedadHielo y agua Parece que el motor funciona excesivamente¿Está la presión de agua a por lo menos 35 lbs/pulg² Nota Esto es una indicación de baja presión de aguaPautas de aplicación/Parámetros para el suministro de agua Hoja DE Datos DEL RendimientoModelo UKF8001AXX-200 Capacidad 200 galones 757 litros Esta garantía limitada no cubre Whirlpool CorporationGarantía Limitada Exclusiones DE LA GarantíaSécurité DU Réfrigérateur Instructions Dutilisation DU RéfrigérateurNettoyage avant l’utilisation Instructions D’INSTALLATIONDéballage duréfrigérateur Avant de jeter votre vieux réfrigérateur ou congélateurMéthode recommandée de mise à la terre Exigences demplacementSpécifications électriques Outillage Requis Spécifications de l’alimentationen eauRaccordement de la canalisation deau Alimentation en eau par osmose inverseRaccordement au réfrigérateur Achever l’installationPorte standard Portes et tiroir du réfrigérateurPorte à deux battants Porte du compartiment de congélation Réinstallation des portes et des charnièresCaisse Porte du compartiment de réfrigérationDéposer la façade du tiroir Réinstaller la façade du tiroirRetirer et réinstaller le tiroir du congélateur Portes à deux battantsPorte standard Porte du compartiment de congélation De la portePorte standard Tiroir de congélation Portes à deux battants Charnières supérieuresFermeture et alignement de la porte Utilisation DU RéfrigérateurOuverture et fermeture des portes Machine à glaçons Utilisation des commandesHumidity Control Commande dhumidité sur certains modèles Réglage delhumidité dans le bac à légumesDistribution d’eau Remplacement du filtre à eauDistributeur d’eau Système defiltrationde leauNettoyage de votre réfrigérateur Remplacement del’ampoule d’éclairageEntretien DU Réfrigérateur NettoyageLe moteur semble trop tourner DépannageFonctionnement du réfrigérateur Le réfrigérateur ne fonctionne pasGlaçons et eau Température et humiditéHeures pour la fabrication de nouveaux glaçons Système de filtration d’eau intérieur Feuilles DE Données SUR LA PerformanceModèle UKF8001AXX-200 /Capacité 200 gallons 757 litres W10366205A EN/FR PN W10366204A Garantie DE Gros Appareil Ménager Whirlpool CorporationGarantie Limitée Éléments Exclus DE LA Garantie