Changing a Cycle or Setting
If your dishwasher has more than one wash cycle, you can change a cycle anytime during a cycle.
1.Lift the door latch to stop the cycle.
2.Turn the Cycle Control knob clockwise.
3.Check the detergent dispensers. They must be filled properly for the new cycle.
NOTE: Turning the Cycle Control knob can cause the covered Detergent Dispenser section to open and release the detergent. Check the covered section if the cycle uses detergent in both sections.
4.Close the door firmly until it latches. The dishwasher starts a new cycle.
Adding Items During a Cycle
You can add an item anytime before the main wash starts, or the Cycle Control knob reaches Light Wash.
1.Lift up the door latch to stop the cycle. Wait for the spraying action to stop before opening the door.
2.Open the door and add the item.
3.Close the door, but do not latch it. Wait 30 seconds for the air in the dishwasher to warm up. This reduces the amount of moisture escaping from the vent when restarting a cycle.
4.Close the door firmly until it latches. The dishwasher resumes the cycle.
Option Selections
You can change an option anytime before the selected option begins. For example, you can press an unheated drying option any time before drying begins.
No Heat Dry
Select this
The dishes take longer to dry and some spotting can occur. For best drying, use a liquid rinse aid. Some items (such as plastics) may need towel drying.
NOTE: Rinse Only automatically uses this option. No Heat Dry is an option with all other cycles.
Low Energy Washing (on some models)
Select this low energy washing option to reduce water temperature during the main wash and final rinse. This will reduce the amount of electricity needed to run the dishwasher.
NOTE: Low Energy Washing (on some models) is an option with all cycles.
Delay Hours (on some models)
Select this option to run your dishwasher at a later time or during
To delay the start
1.Close the door.
2.Select a wash cycle and option.
Press the desired cycle. Turn the Cycle Control knob clockwise to the number of hours you want the dishwasher to delay the start.
The dishwasher starts the cycle in the selected number of hours. You can add items while the time is counting down.
3.Close and latch the door. The Cycle Control knob will not advance if the door is unlatched.
NOTES:
■To cancel the delay, turn the Cycle Control knob to the desired cycle.
■Rinse Only and the Light Wash cycles cannot be delayed.
IMPORTANT:
■Operate your dishwasher only when you are at home.
■If your home is equipped with a water softener, do not start the dishwasher during the regeneration of the softener.
13