Whirlpool 2206106 manual FactoryTrimKit, Water System Preparation, Removing the Door Panels

Page 8

4.RUN WATER THROUGH THE DISPENSER UNTIL THE WATER RUNS CLEAR (about 2-3 gallons or 6-7 minutes). This will clean the system and clear air from the lines. Additional flushing may be required in some households.

NOTE: As air is cleared from the system, water may spurt out of the dispenser.

5.Open the refrigerator door and inspect the filter system for water leaks. If you see water leaks, see the “Troubleshooting” section.

NOTE: You can run the dispenser without a water filter cartridge. Your water will not be filtered.

FactoryTrimKit

(onsomemodels)

There may be an occasion when you will need to remove the factory-installed trim kit, such as moving the refrigerator to a new home or installing custom-made decorator panels. Please read all instructions carefully before removing the trim kit and decorator panels.

2 1

Water System Preparation

Please read before using the water system.

Immediately after installation, follow the steps below to make sure that the water system is properly cleaned.

1.Open the freezer door and turn off the ice maker. For Style 1 lift up the wire shut-off arm as shown. For Style 2 move the switch to the OFF (right) setting as shown.

Style 1

MAX

NORMAL

Style 2

2.Flush the water system by dispensing and discarding

2 to 3 gallons (approximately 6 to 7 minutes) of water through the dispenser. This will clean the system and help clear air from the lines. Additional flushing may be required in some households.

3.Open the freezer door and turn on the ice maker. For Style 1 lower the wire shut-off arm. For Style 2 move the switch to the ON (left) position. Please refer to the “Ice Maker and Storage Bin” features section for further instructions on the operation of your ice maker.

Allow 24 hours to produce the first batch of ice.

Discard the first three batches of ice produced.

Depending on your model, you may want to select the maximum ice feature to increase the production of ice. To do so, set the switch on the front of the ice maker to MAX.

 

 

3

 

2

1

1

2

Freezer Door

Refrigerator Door

1.Decorator Panels

2.Filler Panels

3.Handles

Removing the Door Panels

NOTE: When removing and replacing decorator panels, only the handle is removed. All other trim pieces remain attached to the doors.

1.Remove the refrigerator and freezer handles:

Using a Phillips screwdriver, remove the screws that hold each handle in place.

Lift off handle. Make sure you keep screws for reattaching handles.

2.Remove the door panels:

Open refrigerator or freezer door.

Slide out decorator panel and filler board.

Repeat process for other panels and filler boards.

Store panel and filler boards carefully to prevent scratching.

Replacing the Door Panels

1.Replace the refrigerator or freezer door panels:

Open refrigerator or freezer door.

Carefully slide the ¹⁄₈ in. decorator panel into place behind the side trim.

Push the filler board into place behind the decorator panel.

Repeat process for other panels and filler boards.

2.Attach the handles:

NOTE: Freezer door handle is notched to fit around the dispenser panel.

Align the top of the refrigerator or freezer handle flush with the top trim. Fasten the handle to the refrigerator or freezer door with the screws, using a Phillips screwdriver.

Repeat the process for the other handle.

8

Image 8
Contents 2206106 Table of Contents Table DES MatièresRefrigerator Safety Before you throw away your old refrigerator or freezerInstalling Your Refrigerator Cleaning before useUnpacking Your Refrigerator Space RequirementsScrew 1 AS Shown in Diagram Electrical RequirementsRemoving the Doors Recommended grounding methodConnecting the Refrigerator To a Water Source Shown in DiagramRead all directions carefully before you begin Cold water supplyInterior Water Filter Installation Installing the interior water filter cartridgeConnecting to refrigerator OnsomemodelsFactoryTrimKit Water System PreparationRemoving the Door Panels Replacing the Door PanelsCare of Decorator Panels Installing Custom Wood PanelsBase Grille Using Your Refrigerator Door ClosingUnderstanding Sounds You May Hear Ensuring Proper Air CirculationSetting the Controls Adjusting Control SettingsCONDITION/REASON Adjustment RecommendedOn some models Refrigerator FeaturesWater and Ice Dispensers Base Grille Water Filtration Monitoring System Refrigerator Shelves Lateral Adjustable ShelfInterior Water Filtration System Adjustable Flip-up Shelf Flip-up ShelfConvertible Vegetable/Meat Drawer Crisper and Covers Deli DrawerConvertible Vegetable/Meat Drawer Temperature Control Onsome modelsAccessoryCrisper Humidity Control Utility or Egg BinIce Maker and Storage Bin Freezer FeaturesOn somemodels Accessory Door Features Freezer ShelfFreezer Basket Door RailsCleaning Your Refrigerator Caring for Your RefrigeratorDoor Bins Can RackPower Interruptions Vacation and Moving CareTroubleshooting Ice maker is producing too little ice Off-taste, odor or grey color in the iceIce dispenser will not operate properly Water dispenser will not operate properlyTemperature is too warm Water or ice is leaking from the dispenserDispenser water is not cool enough Divider between the two compartments is warmAssistance Or Service AccessoriesU.S.A CanadaKitchenaid Refrigerator Warranty KitchenAid will not pay forWater Filter Certificates Page MCL Product Data SheetsEPA Base Grille Water Filtration System Model WF-NL300/NL300 Average Maximum Minimum% Average% NSF Test ReductionSécurité DU Réfrigérateur Avant de jeter votre vieux réfrigérateur ou congélateurInstallation DU Réfrigérateur Déballage de votre réfrigérateurEspacement requis Nettoyage avant l’utilisationMéthode recommandée de mise à la terre Spécifications électriquesEnlèvement des portes Outils requisRaccordement du réfrigérateur à une Canalisation d’eau Arrivée d’eau froideEnlever LA VIS 1 TEL QU’ILLUSTRÉ Dans LE Schéma PAS Enlever LA VIS 1 TEL QU’ILLUSTRÉ Dans LE SchémaInstallation de la cartouche de filtre à eau intérieur Système intérieur de filtration d’eauSurcertains modèles Raccordement à une canalisation d’eauPréparation du système d’eau Ensembles décoratifs de l’usineEnlèvement des panneaux de la porte Porte Du congélateur Du réfrigérateurEntretien des panneaux décoratifs Remplacement des panneaux de porteInstallation de panneaux en bois sur commande Réinstallation de la grille de la base Grille de la baseFermeture des portes Lesbruitsdel’appareilquevouspouvez EntendrePours’assurer d’une circulationd’air Appropriée Réglagedes commandesUtilisation DU Réfrigérateur CONDITION/RAISON Recommandé Ajustement desréglages de contrôleDistributeurs d’eau et de glaçons Le distributeur de glaçonsLe distributeur d’eau Lumière du distributeurVerrouillage du distributeur sur certains modèles Distribution de glaçonsUtilisation de le distributeur sans filtre à eau Sur certains modèlesFiltre à eau sans indicateur lumineux sur certains modèles Tablette réglable latérale Système de filtration d’eau intérieurTablettes du réfrigérateur Tablette relevable Tablette relevable ajustableTiroir pour spécialités alimentaires Tiroiràlégumes/viandeconvertible,bac Légumes et couverclesEmplacement de commande d’humidité Réglage de l’humidité dans le bac à LégumesGuide d’entreposage des viandes Ajustement du réglageSurcertainsmodèles-Accessoire Sur certains modèles -AccessoireCasier utilitaire ou oeufrier Casier à vin ou porte-cannettes BouteillesArrêt de la machine à glaçons Caractéristiques DE LA Porte Tablette de congélateurTringlesdans la porte Panier de congélateurRemplacement des ampoules ’éclairage Entretien DE Votre RéfrigérateurPorte-cannettes Nettoyagedu réfrigérateurLumière du tableau de commande Pannes de courantLampe de distributeur sur certains modèles HeuresDépannage Entretienavantlesvacancesoulorsd’un DéménagementLe moteur semble fonctionner excessivement Le réfrigérateur semble faire trop de bruitLa machine à glaçons ne produit pas de glaçons La machine à glaçons produit trop peu de glaçonsLe distributeur de glaçons ne fonctionne pas correctement Le distributeur d’eau ne fonctionne pas bien’eau ou la glace coule du distributeur Un glaçon est-il coincé dans la goulotte?’eau du distributeur n’est pas assez froide La cloison entre les deux sections est tièdeLa température est trop tiède Il y a une accumulation d’humidité à l’intérieurAssistance OU Service AccessoiresAux États-Unis Au CanadaGarantie Limitée À VIE KitchenAid ne paiera pas pourGarantie Complète DE UN AN SUR LE Réfrigérateur Feuilles DE Données SUR LE Produit Affluent Effluent De réd Numéro de Réduction de Pression d’eau 30 120 lb/po2 207 827 kPa Température d’eauPage 2206106 All rights reserved

2206106 specifications

The Whirlpool 2206106 is a top-of-the-line refrigerator that seamlessly combines stylish design with cutting-edge technology, making it an ideal choice for modern kitchens. This appliance stands out not only for its aesthetic appeal but also for its efficient performance and advanced features that enhance user convenience.

One of the primary features of the Whirlpool 2206106 is its spacious interior. With a generous capacity, it provides ample room for groceries, ensuring that organizing food items is hassle-free. The adjustable shelving allows users to customize the storage space to accommodate items of various sizes, while the crispers are specifically designed to keep fruits and vegetables fresh for longer periods.

The refrigerator is equipped with advanced cooling technology, ensuring that food stays fresher for an extended duration. Its precise temperature management system maintains optimal conditions for different types of food, while the humidity-controlled crisper drawers help preserve produce by reducing moisture loss. This ensures that fruits and vegetables retain their flavor and nutritional value.

Another notable feature is the Adaptive Defrost system, which automatically detects when it’s necessary to defrost, improving energy efficiency while reducing frost buildup. This technology allows for optimal performance without the need for frequent manual defrosting, making it convenient for the user.

Energy efficiency is a hallmark of the Whirlpool 2206106. This model is designed to consume less energy compared to conventional refrigerators, helping users save on energy bills while also being environmentally friendly. Its Energy Star rating reflects its commitment to sustainability without compromising on performance.

In terms of design, the Whirlpool 2206106 boasts a sleek exterior finish that can complement any kitchen décor. The stainless steel finish adds a touch of elegance, making it a focal point in the kitchen. Additionally, the unit is designed with user-friendly controls that allow for quick adjustments to temperature settings and other features, enhancing ease of use.

The Whirlpool 2206106 also includes advanced filtration systems that filter out impurities from the water and ice dispensed, ensuring that users have access to clean and refreshing water at all times. The in-door ice and water dispenser is not only convenient but also space-saving, freeing up valuable interior storage room.

Overall, the Whirlpool 2206106 is a perfect blend of functionality, efficiency, and style, making it a must-have appliance for those seeking a sophisticated and practical refrigeration solution in their homes.