Whirlpool 2206106 Interior Water Filter Installation, Onsomemodels, Connecting to refrigerator

Page 7

3.Locate a ½ in. to 1¹⁄₄ in. (12.7 mm to 3.18 cm) vertical COLD water pipe near the refrigerator.

NOTE: Horizontal pipe will work, but the following procedure

must be followed: Drill on the top side of the pipe, not the bottom. This will help keep water away from the drill. This also keeps normal sediment from collecting in the valve.

4.To determine the length of copper tubing you will need, measure from connection on lower left rear of refrigerator to water pipe. Add 7 ft. (2.1 m) to allow for moving refrigerator for cleaning. Use ¹⁄₄ in. (6.35 mm) O.D. (outside diameter) copper tubing. Be sure both ends of copper tubing are cut square.

5.Using a grounded drill, drill a ¹⁄₄ in. hole in the cold water pipe you have selected.

2.Turn shut-off valve ON. Check for leaks. Tighten any connections (including connections at the valve) or nuts that leak.

1.Cold Water Pipe

2.Pipe Clamp

3.Copper Tubing

4.Compression Nut

5.Compression Sleeve

6.Shut-Off Valve

7.Packing Nut

6.Fasten shut-off valve to cold water pipe with pipe clamp. Be sure outlet end is solidly in the ¹⁄₄ in. drilled hole in the water pipe and that washer is under the pipe clamp. Tighten packing nut. Tighten the pipe clamp screws carefully and evenly so washer makes a watertight seal. Do not overtighten or you may crush the copper tubing, especially if soft (coiled) copper tubing is used. Now you are ready to connect the copper tubing.

7.Slip compression sleeve and compression nut on copper tubing as shown. Insert end of tubing into outlet end squarely as far as it will go. Screw compression nut onto outlet end with adjustable wrench. Do not overtighten.

8.Place the free end of the tubing into a container or sink, and turn ON main water supply and flush out tubing until water is clear. Turn OFF shut-off valve on the water pipe. Coil copper tubing.

Connecting to refrigerator:

1.Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Tighten the compression nut. Do not overtighten. Use the tube clamp on the back of the refrigerator to secure the tubing to the refrigerator as shown. This will help prevent damage to the tubing when the refrigerator is pushed back against the wall. Move to step 2.

1.Tube Clamp

2.Copper Tubing

3.Compression Nut

4.Valve Inlet

3.The ice maker water valve is equipped with a built-in water strainer. If local water conditions require periodic cleaning or a well is your source of water supply, a second water strainer should be installed in the ¹⁄₄ in. (6.35 mm) water line. Obtain a water strainer from your nearest appliance dealer. Install at either tube connection.

4.Plug in refrigerator or reconnect power.

Interior Water Filter Installation

(onsomemodels)

The interior water filter cartridge is located in the upper right- hand corner of the fresh food compartment of the refrigerator. The interior water filter cartridge should be replaced every six months or earlier if the flow of water to your water dispenser or ice maker decreases noticeably. (See “Replacing the interior water filter cartridge” in the features section of this book.)

Installing the interior water filter cartridge

NOTE: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

1.Carefully remove the interior water filter cartridge from its packaging. Remove the red cap from the cartridge.

2.Apply the appropriate month sticker to the cartridge as a reminder to replace the cartridge within six months. Then apply the “Water Filter Replacement Reminder” sticker to your calendar as a reminder to replace the cartridge in six months.

3.Line up the INSTALL mark on the water filter label with the indicator line that is molded into the filter mounting bracket cover. Push the cartridge into the filter mounting bracket.

Twist the cartridge ¹⁄₄ turn to the right to lock it into place. The REMOVE mark should be lined-up with the indicator line located on the front cover.

7

Image 7
Contents 2206106 Table DES Matières Table of ContentsBefore you throw away your old refrigerator or freezer Refrigerator SafetySpace Requirements Installing Your RefrigeratorCleaning before use Unpacking Your RefrigeratorRecommended grounding method Screw 1 AS Shown in DiagramElectrical Requirements Removing the DoorsCold water supply Connecting the Refrigerator To a Water SourceShown in Diagram Read all directions carefully before you beginOnsomemodels Interior Water Filter InstallationInstalling the interior water filter cartridge Connecting to refrigeratorReplacing the Door Panels FactoryTrimKitWater System Preparation Removing the Door PanelsBase Grille Installing Custom Wood PanelsCare of Decorator Panels Ensuring Proper Air Circulation Using Your RefrigeratorDoor Closing Understanding Sounds You May HearRecommended Setting the ControlsAdjusting Control Settings CONDITION/REASON AdjustmentWater and Ice Dispensers Refrigerator FeaturesOn some models Base Grille Water Filtration Monitoring System Interior Water Filtration System Lateral Adjustable ShelfRefrigerator Shelves Deli Drawer Adjustable Flip-up ShelfFlip-up Shelf Convertible Vegetable/Meat Drawer Crisper and CoversUtility or Egg Bin Convertible Vegetable/Meat Drawer Temperature ControlOnsome modelsAccessory Crisper Humidity ControlOn somemodels Accessory Freezer FeaturesIce Maker and Storage Bin Door Rails Door FeaturesFreezer Shelf Freezer BasketCan Rack Cleaning Your RefrigeratorCaring for Your Refrigerator Door BinsVacation and Moving Care Power InterruptionsTroubleshooting Water dispenser will not operate properly Ice maker is producing too little iceOff-taste, odor or grey color in the ice Ice dispenser will not operate properlyDivider between the two compartments is warm Temperature is too warmWater or ice is leaking from the dispenser Dispenser water is not cool enoughCanada Assistance Or ServiceAccessories U.S.AKitchenAid will not pay for Kitchenaid Refrigerator WarrantyWater Filter Certificates Page EPA Product Data SheetsMCL Average Maximum Minimum% Average% NSF Test Reduction Base Grille Water Filtration System Model WF-NL300/NL300Avant de jeter votre vieux réfrigérateur ou congélateur Sécurité DU RéfrigérateurNettoyage avant l’utilisation Installation DU RéfrigérateurDéballage de votre réfrigérateur Espacement requisOutils requis Méthode recommandée de mise à la terreSpécifications électriques Enlèvement des portesPAS Enlever LA VIS 1 TEL QU’ILLUSTRÉ Dans LE Schéma Raccordement du réfrigérateur à une Canalisation d’eauArrivée d’eau froide Enlever LA VIS 1 TEL QU’ILLUSTRÉ Dans LE SchémaRaccordement à une canalisation d’eau Installation de la cartouche de filtre à eau intérieurSystème intérieur de filtration d’eau Surcertains modèlesPorte Du congélateur Du réfrigérateur Préparation du système d’eauEnsembles décoratifs de l’usine Enlèvement des panneaux de la porteInstallation de panneaux en bois sur commande Remplacement des panneaux de porteEntretien des panneaux décoratifs Lesbruitsdel’appareilquevouspouvez Entendre Réinstallation de la grille de la baseGrille de la base Fermeture des portesUtilisation DU Réfrigérateur Réglagedes commandesPours’assurer d’une circulationd’air Appropriée Le distributeur de glaçons CONDITION/RAISON RecommandéAjustement desréglages de contrôle Distributeurs d’eau et de glaçonsDistribution de glaçons Le distributeur d’eauLumière du distributeur Verrouillage du distributeur sur certains modèlesFiltre à eau sans indicateur lumineux sur certains modèles Sur certains modèlesUtilisation de le distributeur sans filtre à eau Tablettes du réfrigérateur Système de filtration d’eau intérieurTablette réglable latérale Tiroiràlégumes/viandeconvertible,bac Légumes et couvercles Tablette relevableTablette relevable ajustable Tiroir pour spécialités alimentairesAjustement du réglage Emplacement de commande d’humiditéRéglage de l’humidité dans le bac à Légumes Guide d’entreposage des viandesCasier à vin ou porte-cannettes Bouteilles Surcertainsmodèles-AccessoireSur certains modèles -Accessoire Casier utilitaire ou oeufrierArrêt de la machine à glaçons Panier de congélateur Caractéristiques DE LA PorteTablette de congélateur Tringlesdans la porteNettoyagedu réfrigérateur Remplacement des ampoules ’éclairageEntretien DE Votre Réfrigérateur Porte-cannettesHeures Lumière du tableau de commandePannes de courant Lampe de distributeur sur certains modèlesEntretienavantlesvacancesoulorsd’un Déménagement DépannageLa machine à glaçons produit trop peu de glaçons Le moteur semble fonctionner excessivementLe réfrigérateur semble faire trop de bruit La machine à glaçons ne produit pas de glaçonsUn glaçon est-il coincé dans la goulotte? Le distributeur de glaçons ne fonctionne pas correctementLe distributeur d’eau ne fonctionne pas bien ’eau ou la glace coule du distributeurIl y a une accumulation d’humidité à l’intérieur ’eau du distributeur n’est pas assez froideLa cloison entre les deux sections est tiède La température est trop tièdeAu Canada Assistance OU ServiceAccessoires Aux États-UnisGarantie Complète DE UN AN SUR LE Réfrigérateur KitchenAid ne paiera pas pourGarantie Limitée À VIE Feuilles DE Données SUR LE Produit Pression d’eau 30 120 lb/po2 207 827 kPa Température d’eau Affluent Effluent De réd Numéro de Réduction dePage All rights reserved 2206106

2206106 specifications

The Whirlpool 2206106 is a top-of-the-line refrigerator that seamlessly combines stylish design with cutting-edge technology, making it an ideal choice for modern kitchens. This appliance stands out not only for its aesthetic appeal but also for its efficient performance and advanced features that enhance user convenience.

One of the primary features of the Whirlpool 2206106 is its spacious interior. With a generous capacity, it provides ample room for groceries, ensuring that organizing food items is hassle-free. The adjustable shelving allows users to customize the storage space to accommodate items of various sizes, while the crispers are specifically designed to keep fruits and vegetables fresh for longer periods.

The refrigerator is equipped with advanced cooling technology, ensuring that food stays fresher for an extended duration. Its precise temperature management system maintains optimal conditions for different types of food, while the humidity-controlled crisper drawers help preserve produce by reducing moisture loss. This ensures that fruits and vegetables retain their flavor and nutritional value.

Another notable feature is the Adaptive Defrost system, which automatically detects when it’s necessary to defrost, improving energy efficiency while reducing frost buildup. This technology allows for optimal performance without the need for frequent manual defrosting, making it convenient for the user.

Energy efficiency is a hallmark of the Whirlpool 2206106. This model is designed to consume less energy compared to conventional refrigerators, helping users save on energy bills while also being environmentally friendly. Its Energy Star rating reflects its commitment to sustainability without compromising on performance.

In terms of design, the Whirlpool 2206106 boasts a sleek exterior finish that can complement any kitchen décor. The stainless steel finish adds a touch of elegance, making it a focal point in the kitchen. Additionally, the unit is designed with user-friendly controls that allow for quick adjustments to temperature settings and other features, enhancing ease of use.

The Whirlpool 2206106 also includes advanced filtration systems that filter out impurities from the water and ice dispensed, ensuring that users have access to clean and refreshing water at all times. The in-door ice and water dispenser is not only convenient but also space-saving, freeing up valuable interior storage room.

Overall, the Whirlpool 2206106 is a perfect blend of functionality, efficiency, and style, making it a must-have appliance for those seeking a sophisticated and practical refrigeration solution in their homes.