3.Lower the front of the shelf and check to make sure that the shelf is securely in position.
Lateral Adjustable Shelf
(on somemodels)
To slide the shelf from side to side:
1.Lift up on the front of shelf and slide to the desired location.
2.Lower shelf to the level position.
NOTE: You do not have to remove small items from the shelf before moving it from side to side. You may need to remove larger items.
To remove the shelf:
NOTE: The shelf is heavy and must be removed using both hands.
1.Hold the back of the shelf with one hand.
2.Lift the front of the shelf with the other hand to a 45° angle and lower it slightly to release it from the upper channel of the track. Pull the shelf straight out.
To remove and replace the shelf track:
1.Remove the shelf track by lifting both sides of the track slightly and pulling the track straight out.
2.Replace the track by guiding the track hooks into the shelf support slots on the back wall.
NOTE: Make sure that both sets of track hooks are in the slots and that the slots are parallel with each other.
3.Push the track back and down securely into the shelf supports.
To replace the shelf:
NOTE: Make sure that both of the rear shelf slides are securely in the track before letting go of the shelf. The lateral shelf may be difficult to install if the track is placed too close to the refrigerator ceiling. Reposition the track on a lower rung until the shelf can be tilted enough to easily slide into the track.
1.Hold the shelf at the front and tip the front at a 45° angle to the track.
2.Insert both of the rear shelf slides into the upper channel of the track, and lower the front of the shelf into place.
Meat Drawer and Cover
(on some models)
To remove and replace the meat drawer:
1.Remove the meat drawer by sliding it out to the stop. Lift the front of meat drawer with one hand while supporting the bottom of drawer with other hand. Slide drawer out the rest of the way.
2.Replace the meat drawer by guiding it into the meat cover supports and pushing it in until it stops.
To remove and replace the meat drawer cover:
1.Remove the meat drawer. Remove the cover by tilting up the front of the cover and lifting at the back. Pull the cover straight out.
2.Replace the cover by guiding the rear hooks into the shelf supports. Tilt the cover up at the front until the rear hooks drop into the slots.
3.Lower the front of the cover to a level position and replace the meat drawer.
Meat storage guide
Store most meat in original wrapping as long as it is airtight and
Fresh fish or shellfish | use same day as purchased | |
Chicken, ground beef, variety meats (liver) | ||
Cold cuts, steaks/roasts | ||
Cured meats | ||
Leftovers - Cover leftovers with plastic wrap, aluminum foil, or plastic containers with tight lids.
Crisper and Crisper Cover
(on some models -Accessory)
To remove and replace the crisper(s):
1.Slide crisper(s) straight out to the stop. Lift the front of the crisper(s) and slide out the rest of the way.
2.Replace the crisper(s) by sliding back in fully past the drawer stop.
To remove the crisper(s) cover:
1.Remove crisper(s).
2.Holding the glass insert firmly with one hand, press up in center of glass insert until it rises above the plastic frame. Carefully, slide the glass insert forward to remove.
12