INSTALLING YOUR
REFRIGERATOR
Unpacking Your Refrigerator
WARNING
Excessive Weight Hazard
Use two or more people to move and install refrigerator.
Failure to do so can result in back or other injury.
Remove shelves from the shipping position (shelves are shipped upside down):
1.Grasp the front of the upper shelf with one hand and use the other hand to remove packing material from the shelf area.
2.Lower the front of the upper shelf until shelf hooks can be removed from the shelf supports and pull the shelf forward.
3.Flip the shelf over and insert the rear shelf hooks into the shelf supports. Tilt the front of shelf up until rear shelf hooks drop into the shelf supports.
4.Lower the front of the shelf and check to make sure that it is securely in position.
Removing packaging materials
■Remove tape and glue from your refrigerator before using. To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can also be easily removed by rubbing a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.
■Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your refrigerator. For more information, see “Refrigerator Safety” section.
■On some models, shelves, bins, door shelf rails, and other feature parts may be packaged in the Interior FeaturePak. Follow the instructions contained in the package for proper assembly.
■Depending on your model, to remove the protective (transparent) film that is on the nameplate, which is located on the freezer handle, use your fingernail and peel off the film, starting from one side and peeling to the other.
IMPORTANT: Depending on your model, do not remove the white foam air return insert that is located behind the control panel on the ceiling of the refrigerator. The insert is part of the refrigerator and not part of the packing material. If the insert is removed, ice may migrate down from the freezer and cause icicles to form.
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the refrigerator for cleaning or service, be sure to protect the floor. Always pull the refrigerator straight out when moving it.
Do not wiggle or “walk” the refrigerator when trying to move it, as floor damage could occur.
Cleaning before use
After you remove all of the package materials, clean the inside of your refrigerator before using it. See the cleaning instructions in the “Caring for your Refrigerator” section.
Important information to know about glass shelves and covers:
Do not clean glass shelves or covers with warm water when they are cold. Shelves and covers may break if exposed to sudden temperature changes or impact, such as bumping. For your protection, tempered glass is designed to shatter into many small,
Location Requirements
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fire.
■To ensure proper ventilation for your refrigerator, allow 1 in. (2.5 cm) space at the top and back and ¹⁄₂ in. (1.25 cm) on each side of the refrigerator.
■If you are installing your refrigerator next to a fixed wall, leave 2¹⁄₈" (5.4 cm) minimum on each side (depending on your model) to allow for the door to swing open.
1" (2.5 cm)
21/8" (5.4 cm)
■If your refrigerator has an ice maker, make sure you leave some extra space at the back for the water line connections.
NOTE: Do not install the refrigerator near an oven, radiator, or other heat source, nor in a location where the temperature will fall below 55°F (13°C).
4