Broan QP442SS, QP430SS, QP436SS Warranty, Service Parts, Lamp Socket Bracket Light Screws Panel

Page 8

MODELS QP430SS • QP436SS • QP442SS

LAMP SOCKET

BRACKET

LIGHT

SCREWS

PANEL

To change the depth of bulb sockets:

1.Remove bottom pan (See Step 5).

2.Remove 2 Light Panel Screws and Light Panel. Set screws aside.

3.Loosen 2 Screws holding Lamp Socket Bracket to Light Panel.

4.Adjust socket/bracket to desired depth.

5.Re-tighten screws securely.

6.Re-attach light panel and bottom pan.

WARRANTY

One Year Limited Warranty

Broan-NuTone warrants to the original consumer purchaser of its products that such products will be free from defects in materials or workmanship for a period of one (1) year from the date of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

During this one year period, Broan-NuTone will, at its option, repair or replace, without charge, any product or part which is found to be defective under normal use and service. THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS, TUBES, HALOGEN AND INCANDESCENT BULBS, FUSES, FILTERS, DUCTS, ROOF CAPS, WALL CAPS AND OTHER ACCESSORIES FOR DUCTING. This warranty does not cover (a) normal maintenance and service or (b) any products or parts which have been subject to misuse, negligence, accident, improper maintenance or repair (other than by Broan-NuTone), faulty installation or installation contrary to recommended installation instructions.

The duration of any implied warranty is limited to the one year period as specified for the express warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above limitation may not apply to you.

BROAN-NUTONE’S OBLIGATION TO REPAIR OR REPLACE, AT BROAN- NUTONE’S OPTION, SHALL BE THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY. BROAN-NUTONE SHALL NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. This warranty supersedes all prior warranties.

To qualify for warranty service, you must (a) notify Broan-NuTone at the address or telephone number below, (b) give the model number and part identification and (c) describe the nature of any defect in the product or part. At the time of requesting warranty service, you must present evidence of the original purchase date.

Broan-NuTone LLC, 926 W. State Street, Hartford, Wisconsin 53027 www.broan.com 800-558-1711

Rev. 08/2007

Page 8

SERVICE PARTS

KEY NO. PART NO.

DESCRIPTION

1

97018567

7” Round Duct Plate (includes mounting hardware)

2

97018257

User Interface Assembly Black (includes interface,

 

 

nameplate, mounting hardware)

3

99528259

Nameplate, Black

4

97018568

Capacitor Kit (includes wire nuts, mounting screw)

5

97018227

Light Panel RH Stainless

 

 

(includes mounting hardware)

6

97018205

Filter Kit for 30” (2 per bag)

 

97018206

Filter Kit for 36” (2 per bag)

 

97018207

Filter Kit for 42” (3 per bag)

7

97018569

Blower Wheel (includes spring clip)

8

97018570

Motor Kit (includes motor, isolators,

 

 

mounting hardware)

9

97018571

Damper / Duct Connector (includes mounting

 

 

hardware)

10

97018231

Light Panel LH Stainless (includes mounting

 

 

hardware)

11

97017731

Lamp Socket (includes lamp socket, wire nuts,

 

 

mounting screws)

12

97018233

Lamp Socket Bracket

13

97018572

Bottom Pan 30” (includes mounting hardware)

 

97018573

Bottom Pan 36” (includes mounting hardware)

 

97018574

Bottom Pan 42” (includes mounting hardware)

14

97018260

Circuit Board

15

97018262

Transformer (includes mounting hardware)

16

97018575

Vertical Diverter

17

97018582

Rubber Bushing

*

97017735

Parts Bag

*

99526707

Suction Cup Tool

*

97018252

Heat Sensor

*

97018253

Fuse

*

97018261

Ribbon Cable Kit (contains 3)

*

V05921

50W Halogen GU10 Bulb

* Not shown

Order replacement parts by PART NO. - not by KEY NO.

99527577B

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Evacuate and Call the Fire Department For Domestic Cooking onlyTo Reduce the Risk of a Range TOP Grease Fire Contents Cleaning & MaintenanceLight 3-Pushbutton Switches 4-light Settings FAN 3-Pushbutton Switches 4-fan speedsMinute Delay OFF TimerFeature Menu Clock SettingRemote Control Heat Sentry SystemMAKE-UP AIR Damper FusesPrepare Hood Location Inch Round Discharge Duct & Electrical CutoutsVertical Discharge Horizontal DischargeFor 30 Model only Vertical 7 Round & 3¼ X 14 Installation onlyPrepare the Hood HOW to Change Light Bulbs Install the HoodConnect the Wiring Warranty Service PartsLamp Socket Bracket Light Screws Panel KEY NO. Part no DescriptionPour Usage Domestique Seulement Avertissement Avertissement Cet appareil doit être relié à une mise à la terrePour usage intérieur seulement Cette hotte n’est pas conçue pour servir d’étagèreContenu FonctionnementNettoyage ET Entretien RemarqueArrêt Différé DE 10 Minutes MinuterieMenu DE Fonctions Réglage DE L’HEURETélécommande Système DE Détecteur DE ChaleurFusibles Clapet D’AIR DE CompensationEmplacement DES VIS DE Montage ’UNE Hotte DE 76 CM 30 POEnlevez et jetez la plaque de répartiteur vertical Préparation DE LA HottePour Modèle 76 CM 30 PO Uniquement Connectez le câble électrique de la maison avec les Installation DE LA HotteRaccord DU Câblage Garantie DescriptionSupport DE Socle ’AMPOULE Panneauvis ’ÉCLAIRAGE DescriptionSólo debe usarse bajo techo Solamente Para Cocinar EN Casa Advertencia AdvertenciaPrecaución Contenido FuncionamientoLimpieza Y Mantenimiento NotaApagado CON Retardo DE 10 Minutos TemporizadorMenú DE Funciones Ajustes DEL RelojControl Remoto Sistema Heat SentryRegulador DE Aire DE Repuesto VA a Instalar LA Campana Conducto Redondo Para Descarga DE 7 PulgCM Y Cortes Para Cables Eléctricos Ubicaciones Para Tornillos DE MontajePrepare LA Campana Sólo Para EL Modelo DE 30 Pulg CMInstale LA Campana Conecte EL CableadoQuite la cubierta de la caja de cableado eléctrico Conecte el cable eléctrico de la casa al cableado deGarantía Piezas DE ServicioQuite el recipiente inferior vea el paso Descripción

QP442SS, QP436SS, QP430SS specifications

The Broan QP436SS, QP442SS, and QP430SS range hoods are exceptional appliances designed to enhance kitchen functionality while maintaining aesthetic appeal. These models offer a blend of performance, efficiency, and style, making them ideal choices for modern kitchens.

Starting with the Broan QP436SS, this model boasts a sleek stainless steel design that seamlessly integrates into various kitchen decors. Its Ducted or Ductless options provide flexibility for installation, allowing the user to choose the best configuration for their space. It features a powerful 750 CFM blower, which efficiently captures and eliminates smoke, odors, and grease, ensuring a clean cooking environment. The two-speed fan control allows for easy adjustments based on cooking needs, while the dishwasher-safe stainless steel filters simplify maintenance.

Moving on to the Broan QP442SS, this model enhances the user experience with its advanced features. It shares the same powerful blower capability of up to 750 CFM, but what sets it apart is its unique design. The QP442SS includes a seamless design that reduces the visual clutter, and the integrated lighting, featuring bright LED bulbs, illuminates the cooking surface effectively. This model also offers quiet operation, ensuring that it performs efficiently without disrupting the serenity of your home.

Lastly, the Broan QP430SS combines function with sophisticated style. Designed for those who prioritize aesthetics without compromising on performance, this model features a modern curved glass design. With a maximum airflow of 450 CFM, it's ideal for smaller kitchens or lighter cooking tasks, striking a balance between power and quiet functionality. One of its standout features is the intuitive control panel, which includes a three-speed fan and a timer function for added convenience. Additionally, the QP430SS is equipped with energy-efficient LED lighting and easy-to-clean aluminum filters.

In conclusion, the Broan QP436SS, QP442SS, and QP430SS range hoods offer exceptional performance, innovative technology, and stylish design. Whether you have a larger kitchen that requires a robust ventilation solution or a more intimate space needing subtlety, these models cater to various needs while enhancing the overall culinary experience. Each model stands out with its unique characteristics, making them worthy investments for any kitchen renovation or upgrade.
Top Page Image Contents