Blodgett CNV14E, CNV14G manual Gas Hose Restraint

Page 17

Installation

Gas Hose Restraint

If the appliance is mounted on casters, a commer- cial flexible connector with a minimum of 3/4” (1.9 cm) inside diameter must be used along with a quick connect device.

The restraint, supplied with the appliance, must be used to limit the movement of the appliance so that no strain is placed upon the flexible connector. The restraint should be fastened to the base frame of the oven as close to the flexible connector as pos- sible. It should be short enough to prevent any strain on the connector. With the restraint fully stretched the connector should be easy to install and quick connect.

The restraint (ie: heavy gauge cable) should be at- tached without damaging the building. DO NOT use the gas piping or electrical conduit for the at- tachment of the permanent end of the restraint! Use anchor bolts in concrete or cement block. On wooden walls, drive hi test wood lag screws into the studs of the wall.

WARNING!!

If the restraint is disconnected for any rea- son it must be reconnected when the ap- pliance is returned to its original position.

U.S. and Canadian installations

The connector must comply with the Standard for Connectors for Movable Gas Appliances, ANSI Z21.69 or Connectors For Moveable Gas Ap- pliances CAN/CGA-6.16and a quick disconnect device that complies with the Standard for Quick- Disconnect Devices for Use With Gas Fuel, ANSI Z21.41 or Quick Disconnect For Use With Gas Fuel CAN 1-6.9. Adequate means must be provided to

limit the movement of the appliance without de- pending on the connection and the quick discon- nect device or its associated piping.

A drip leg must be used at each appliance. Refer to NFPA54/ANSI Z223.1 - Latest Edition (National Fuel Gas Code) for proper drip leg installation.

General export installations

Installation must conform with Local and National installation standards. Local installation codes and/ or requirements may vary. If you have any questions regarding the proper installation and/or operation of your appliance, please contact your local distributor. If you do not have a local distributor, please call Blodgett Combi at 0011-802-860-3700.

Attachment Plate

Gas Hose

Quick Connect

(secure with leg mount bolt)

Gas Supply Line

 

 

Restraint

IMPORTANT: Cable restraint should be fastened as close as possible to the flexible connector and short enough to prevent any strain on the flexible con- nector.

At maximum stretch of shortened re- straint, the flexible connector should be easy to install and quick to connect.

Installation of Gas Hose and Restraint

(Single Section Shown)

Figure 9

13

Image 17
Contents CNV14E and CNV14G Page Avertissement Page Table of Contents/Table des Matières Description of the Blodgett Combi Convection Oven IntroductionAgency Approvals Canadian InstallationsGeneral Export Installations Owner’s Responsibilities Voltage Phase Max Load amps MotorMaximum shelf loading -- 100 lbs 45.5 Kg Ratings GAS Appliances CNV14G/AAOven Location Oven Location and VentilationMinimum Required ClearancesAttachment Leg AttachmentLEG Options GAS Appliances only Attach the flue vents as shown StackingOven Leveling This oven should be set up in placeOven Leveling Plumbing Connections Use of poor quality water will invali- date your warrantyWater Connection -- CNV14E only Drain ConnectionExport Installations Gas Models Canadian InstallationsElectrical Connections All ModelsGAS Piping Gas ConnectionsExample Pipe Nominal Size, Inches LengthGAS Pressure Pressure Regulation and TestingGas Inlet Orifice Size at Sea Level Manifold Pressure PressureGas Hose Restraint Door Adjustment AdjustmentsElectrical Control Compartment Final Check ListsPlumbing Final Check -- CNV14E only Oven Operational TestsSafety Tips Safety Information for Gas UnitsWhat to do in the event of a power failure General safety tipsControls Identification Gas ControlsOperation Standard ControlsOptional Cook & Hold Temperature Display --- gives cook tem- peratureProgrammed Operation Manual OperationProgramming the Manual KEY Programming the Product KeysOptional Meat Probe Spray Bottle Operating Procedure MaintenanceCleaning the Interior Cleaning and Preventive MaintenanceCleaning the Exterior Preventive MaintenanceDescription du four à convection Combi Certifications Mises en service américaines et canadiennesMise en service dans les autres pays Charges maximales sur une tablette -- 45.5 kg 100 lb Responsabilités du propriétaireCaractéristiques Techniques Appareils Électriques CNV14E/AA AmpèresEmplacement DU Four Emplacement du four et mise de niveau et VentilationDégagement Acceptable AvertissementOptions Montage des piedsMontage Assurez-vous que les roulettes avant sont bloquéesREMARQUEPour les appareils électriques Passez à l’étape SuperpositionMise DE Niveau DU Four Mise de niveau du fourRaccordement DU Drain Raccordement de la plomberieRaccordement À L’EAU CNV14E Seulement Installations dans d’autres pays Modèles à gaz Installations canadiennes et américainesRaccordement à l’électricité Tous les modèlesConduite DE GAZ Raccordement au gazExemple Longueur Diamètre interne po Du tuyau 2 poInstallation dans les autres pays Installations américaines et canadiennesRégulation DE LA Pression ET Essais Pression DE GAZCâble d’immobilisation du tuyau à gaz Installation dans un autre paysAjustement DE LA Porte AjustementsListe de vérification finale Compartiment DES Commandes ÉlectriquesVérification Finale DE LA Tuyauterie -- CNV14E Seulement Essais DE Fonctionnement DU FourConseils DE Sécurité Renseignements sur la sécurité des appareils au gazQue faire si vous percevez une odeur de gaz Que faire en cas de panne de courantIdentification DES Commandes Commandes du gazVoyant Indicateur DE Chauffage Commandes standardInterrupteur DU Ventilateur UtilisationIdentification DES Contrôles Cuisson et Pause en OptionTouche Fléchées DE LA Minuterie Touches Fléchées DE TempératureFonctionnement Manuelle Programmation DES Touches DE Produits Programmation DE LA Touche Cuisson Manuelle Sonde thermique optionnelle Commande DE LA Sonde ThermiqueConnecteur DE LA Sonde Thermique FonctionnementProcédure de fonctionnement du pulvérisateur EntretienNettoyage DE L’INTÉRIEUR Nettoyage et entretien préventifNettoyage DE L’EXTÉRIEUR Entretien PréventifInsert Wiring Diagram Here Placer Schéma DE Câblage ICI

CNV14E, CNV14G specifications

The Blodgett CNV14G and CNV14E are advanced commercial convection ovens designed for high-volume food service operations. Renowned for their reliability, efficiency, and versatility, these ovens are a mainstay in restaurants, catering businesses, and institutional kitchens. They are engineered to meet the demanding needs of professional chefs while ensuring consistent cooking results every time.

One of the standout features of the CNV14G and CNV14E is their exceptional capacity. With the ability to hold up to 14 full-size pans, these ovens can easily accommodate large batches of food. This is ideal for establishments that need to prepare numerous meals simultaneously, enabling efficient workflow in busy kitchens. The spacious interior is designed to provide even air circulation, ensuring uniform cooking results, which is crucial for maintaining the quality and consistency of dishes.

Both models are equipped with state-of-the-art digital controls that allow chefs to set precise temperatures and cooking times. The control panel is user-friendly, enabling quick adjustments to be made during operation. This technological feature not only enhances user experience but also helps in achieving optimal cooking results for various types of food.

The Blodgett CNV14G and CNV14E are designed with energy efficiency in mind. They utilize advanced insulation and heating technologies, which helps reduce energy consumption while maintaining high performance levels. This energy efficiency is not only cost-effective but also positively contributes to environmentally friendly kitchen practices.

Another key characteristic is the heavy-duty construction of these ovens, built to withstand the rigors of daily use in a commercial setting. The stainless steel exterior ensures durability and easy cleaning, while the oven’s robust interior is designed to resist wear and tear from frequent use.

A notable feature of both models is their ability to produce steam when required, allowing for versatile cooking methods such as baking, roasting, and steaming. This flexibility makes the CNV14G and CNV14E suitable for a wide range of menu items, from crispy roasted vegetables to soft, fluffy breads.

In summary, the Blodgett CNV14G and CNV14E convection ovens are exemplary choices for any commercial kitchen looking for reliability, efficiency, and versatility. Their impressive features, advanced technology, and robust design continue to set industry standards for professional cooking equipment.