Blodgett KLT-G Series manual Operation, GAS Control Instructions, Lighting

Page 10

3.0OPERATION

Contact the factory, the factory representative or a local service company to perform

maintenance and repairs should the appliance malfunction.

CAUTION: If you smell gas during the lighting procedure, immediately shut off the gas supply until the leak has been corrected.

WARNING: In the event of main burner ignition failure, a 5 minute purge period must be observed prior to re-establishing ignition source.

WARNING: In the event you smell gas, shut down equipment at the main shut off valve and contact the local gas company or gas supplier for service.

GAS CONTROL INSTRUCTIONS

The units do not require “lighting” the pilot with a match.

A. Lighting

NOTE: Unit is shipped with gas combination valve turned “on”.

1.Open manual gas shut off valve.

2.Set thermostat to OFF, and kettle in fully upright position, turn power switch ON.

3.Set thermostat to maximum, initiating a 30 second pre-purge. Red “COOKING” pilot will come on, and after 30 seconds, the green “IGNITION” pilot will come on, lighting the main burners.

10

Image 10
Contents Important Notes for Installation and Operation KLT-G SeriesPage Table of Contents Description Service Connections Model GAS SupplySides Inches Back Installation Installation Codes and StandardsFloors NON-COMBUSTIBLE Installation To InstallGAS Connection Water Connection Electrical ConnectionPerformance Check GAS Control Instructions OperationLighting Daily Shutdown Complete ShutdownRED Cooking Light Front Panel Controls Power SwitchGreen Ignition Light Amber LOW Water LightPressure Gauge Dial SettingThermostat Sight GlassDaily Operation Pressure Relief ValveEND USE Tips GAS Saving Tips Cleaning Instructions DRAW-OFF Valve Cleaning Cleaning InstructionsDairy DRAW-OFF Valve Cleaning What to do if Surface Rust Appears Stainless SteelCleaning Instructions Monthly MaintenanceDaily Twice a Year minimumAdjustments Service GeneralManifold Pressure Pressure Switch To Adjust Pressure Switch Adding Water Low water light comes on For ReferenceRE-ESTABLISHING Vacuum Adjustments Troubleshooting ProblemLook for Shutter Settings Kettle Size/Gas Type Natural PropaneShutter setting at Chemical Product and Company Identification Material Safety Data Sheet Preparation InformationMaterial Safety Data Sheet ProductHazards Identification Emergency Overview Product DOWFROST* HD Heat Transfer FLUID, DyedFire Fighting Measures Flammable Properties First AIDFlammability Limits Material Safety Data Sheet Exposure CONTROLS/PERSONAL Protection Handling and StoragePersonal Protective Equipment Physical and Chemical Properties Stability and ReactivityMutagenicity Environmental FateTransport Information Chemical Name CAS Number List RegulationsToxic Substances Control ACT Tsca PA1Canadian Environmental Protection ACT Cepa Canadian RegulationsOther Information