Zephyr AK7500ASX Mounting the Range Hood, This is the top of the board used to hang the hood

– Mounting the Range Hood

			www.zephyronline.com
! CAUTION: At least two installers are
required due to the weight and size of the			C/L
hood.
1.	Measure distance from range top to hood bottom (26” min) Level	B
	and mark line A.		wood board	4”
2.	Plum and mark center line.
3.	Mark mounting height line B. (12 3/8” from line A)			12 3/8”
	(This is the top of the board used to hang the hood)
4.	Mark center line of wood board and align top of board with line B.	A
	Secure wood board to studs using (4) M4 wood screws. Wood Board
	Dimensions: (W x D x H)			min
	AK7500ASX - 28” x 3/4” x 4”
	AK7536ASX - 34” x 3/4” x 4”			26”
	AK7548ASX - 46” x 3/4” x 4”
5.	If horizontally ducting hood refer to hood specifi cations on page 8 for
	cut-out dimensions.
6.	*Hang hood on wood board and secure using (4) M4 x 16 screws.
7.	Install blower(s). Turn to page 11 for blower installation
	instructions.
8.	Install electrical.
9.	Install duct work and duct tape.		C/L
10. Power up hood and check for leaks around duct tape.
11.	Install optional accessories: duct cover (fig. 2-C), back splash (fig. 2-

D), and/or heat lamp kit (fig. 2-E). (sold separately) For more detailed	fig. 1
instructions refer to manual included with each accessory.

12. Reinstall baffl e fi lters.

Installation

NOTE: If installing a back splash do not install screws at bottom of hood yet. There is a lip on the back splash that needs to be inserted behind the hood first.

fig. 2 - C fig. 2 - D

fig. 2 - E

NUT

SCREW

C

D

E

fig. 2

10