Zephyr AK7548ASX, AK7500ASX, AK7536ASX manual Operation

Page 5

WARNING

TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK.

CAUTION

To reduce risk of fi re and to properly exhaust air outside - Do not vent exhaust air into spaces within walls, ceilings, attics, crawl spaces or garages.

OPERATION

Always leave safety grilles and fi lters in place. Without these components, operating blowers could catch onto hair, fi ngers and loose clothing.

The manufacturer declines all responsibility in the event of failure to observe the instructions given here for installation, maintenance and suitable use of the product. The manufacturer further declines all responsibility for injury due to negligence and the warranty of the unit automatically expires due to improper maintenance.

*NOTE: Please check www.zephyronline.com for revisions before doing any custom work.

ELECTRICAL REQUIREMENTS

Important:

Observe all governing codes and ordinances.

It is the customer’s responsibility:

-To contact a qualifi ed electrical installer.

-To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/NFPA 70 latest edition* or CSA standards C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No.0-M91 - latest edition** and all local codes and ordinances.

If codes permit and a separate ground wire is used, it is recommended that a qualifi ed electrician determine that the ground path is adequate.

Do not ground to a gas pipe.

Check with a qualifi ed electrician if you are not sure the range hood is properly grounded.

Do not have a fuse in the neutral or ground circuit.

*National Fire Protection Association Batterymarch Park, Quincy, Massachusetts 02269 ** CSA International 8501 East Pleasant Valley Road, Cleveland, Ohio 44131-5575

This appliance requires a 120V 60Hz electrical supply and connected to an individual properly grounded branch circuit protected by a 15 or 20 ampere circuit breaker or time delay fuse. Wiring must be 2 wire with ground. Please also refer to Electrical Diagram on product.

A cable locking connector (not supplied) might also be required by local codes. Check with local requirements, purchase and install appropriate connector if necessary.

Important Safety Notice

3

Image 5
Contents Use, Care, and Installation Guide Page Installation Table of ContentsTo Reduce the Risk of Range TOP Grease Fire Important Safety NoticeOperation Parts Supplied List of MaterialsDuct pieces Equivalent number Total Length x used Installation Ducting Calculation SheetDucting InstallationMounting Height & Clearance Some Ducting Options Installation Ducting OptionsBack Installation SpecificationsCable Lock Installation ElectricalElectrical This is the top of the board used to hang the hood Mounting the Range HoodInstallation Single and Dual Internal Blowers Installation CBI-600B Horizontal Ducting Conversion Installation CBI-600B Horizontal Ducting Conversion CBE-1000 Wiring Diagram Installation External Blower PreparationBlower On/Off Features & Controls Touch Controls & FeaturesSurface Maintenance Maintenance Cleaning and Filter RemovalStainless Steel Baffle Filters Removing Baffle FiltersReplacing Light Bulbs Maintenance LightsIssue Cause What to do TroubleshootingTroubleshooting Procedures for Tempest I and Tempest Replacement Parts List of Parts and AccessoriesOptional Accessories DescriptionLimited Warranty