Zephyr AK7536ASX, AK7500ASX Important Safety Notice, To Reduce the Risk of Range TOP Grease Fire

Page 4

Important Safety Notice

READ AND SAVE THESE INSTRUCTIONS

www.zephyronline.com

WARNING

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT USE THIS FAN WITH ANY SOLID-STATE CONTROL DEVICE.

WARNING

TO REDUCE THE RISK OF FIRE ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

a.Use this unit only in the manner intended by the manufacturer, if you have questions, contact the manufacturer.

b.Before servicing or cleaning unit, switch power off at service panel and lock panel to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.

CAUTION

For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors. Take care when using cleaning agents or detergents. Suitable for use in household cooking area.

WARNING

TO REDUCE THE RISK OF RANGE TOP GREASE FIRE:

a.Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.

b.Always turn hood ON when cooking at high heat or when fl aming food

c.Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or fi lter.

d.Use proper pan size. Always use cookware appropriate for the size of the surface element.

e.Keep fan, fi lters and grease laden surfaces clean.

f.Use high setting on hood only when necessary.

g.Don’t leave hood unattended when cooking.

h.Always use cookware and utensils appropriate for the type of and amount of food being prepared.

WARNING

TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP FIRE, OBSERVE THE FOLLOWING:

a.SMOTHER FLAMES with a close-fi tting lid, cookie sheet, or metal tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the fl ames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.

b.NEVER PICK UP A FLAMING PAN – You may be burned.

c.DO NOT USE WATER, including wet dishcloths or towels – a violent steam explosion will result.

d.Use an extinguisher ONLY if:

1.You know you have a Class ABC extinguisher, and you already know how to operate it.

2.The fi re is small and contained in the area where it started.

3.The fi re department is being called.

4.You can fi ght the fi re with your back to an exit

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

a.Installation work and electrical wiring must be done by qualifi ed person(s) in accordance with all applicable codes and standards. Including fi re-rated construction.

b.Suffi cient air is needed for power combustion and exhausting of gases through the fl ue (chimney) of fuel burning equipment to prevent back-drafting. Follow the heating equipment manufacturer’s guideline and safety standards such as those published by the National Fire Protection Association (NFPA) and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE) and the local code authorities.

c.When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.

d.Ducted fans must always vent to the outdoors.

e.If this unit is to be installed over a tub or shower, it must be marked as appropriate for the application and be connected to a GFI (Ground Fault Interrupter protected branch circuit).

g.NEVER place a switch where it can be reached from a tub or shower.

h.Make sure the power is off before installing, wiring or maintenancing.

2

Image 4
Contents Use, Care, and Installation Guide Page Table of Contents InstallationImportant Safety Notice To Reduce the Risk of Range TOP Grease FireOperation List of Materials Parts SuppliedInstallation Ducting Calculation Sheet Duct pieces Equivalent number Total Length x usedMounting Height & Clearance InstallationDucting Installation Ducting Options Some Ducting OptionsInstallation Specifications BackElectrical Installation ElectricalCable Lock Mounting the Range Hood This is the top of the board used to hang the hoodInstallation Single and Dual Internal Blowers Installation CBI-600B Horizontal Ducting Conversion Installation CBI-600B Horizontal Ducting Conversion Installation External Blower Preparation CBE-1000 Wiring DiagramFeatures & Controls Touch Controls & Features Blower On/OffMaintenance Cleaning and Filter Removal Surface MaintenanceStainless Steel Baffle Filters Removing Baffle FiltersMaintenance Lights Replacing Light BulbsTroubleshooting Procedures for Tempest I and Tempest TroubleshootingIssue Cause What to do List of Parts and Accessories Replacement PartsOptional Accessories DescriptionLimited Warranty