Bakers Pride Oven ALF-FC service manual Step Action Display Comments

Automatic Lift Fryer			Operation
	Table 1. System Programming Procedure
STEP	ACTION	DISPLAY	COMMENTS
1	Press the FILTER/OFF/FRY	LOW
	switch to FRY.
2	Press PROG on the keypad.	PROGRAM CODE
3	Input 1712 and ENTER.	PROGRAM SYSTEM
4	Press ENTER.	PROGRAM DEGREES	This command allows you
		°F	to choose the temperature
			scale option you want to
			use. The display will show
			either show °F or °C.
5	Press TOGGLE/CLEAR until the	PROGRAM DEGREES	X refers to the
	desired option is displayed.	X	temperature scale you
			have chosen.
6	Press ENTER.	PROGRAM APL TYPE	This command allows you
		ELECTRIC	to choose the appliance
			type you are using. The
			display may show
			ELECTRIC, GAS OR ALF.
7	Press TOGGLE/CLEAR until the	PROGRAM APL TYPE	X refers to the appliance
	desired option is displayed.	X	type you have chosen.
8	Press ENTER.	PROGRAM MELTCYCL	This command allows you
		YES	to set the melt cycle
			option. This is normally set
			to yes if you are using
			solid shortening. The
			display will show either
			YES or NO.
9	Press TOGGLE/CLEAR until the	PROGRAM MELTCYCL	X refers to the melt cycle
	desired option is displayed.	X	option chosen.
10	Press ENTER.	PROGRAM GLBLFLTR	This command allows you
		0	to specify the total number
			of fry cycles to complete
			among all product
			programs before a
			message is displayed
			reminding you to filter the
			shortening (filter lockout).
11	Press TOGGLE/CLEAR and	PROGRAM GLBLFLTR	X refers to the number of
	input the number of fry cycles	X	program cycles you want
	you want to complete among all		to complete among all
	product programs before		product programs before
	enabling filter lockout.		filtering the shortening.
12	Press ENTER.	PROGRAM SYSTEM
13	Press PROG to exit the	LOW
	programming mode.

18