TC electronic SDN BHD SDN BHD Hard Compression of Vocal Tracks, Controlling Percussive Material

Page 25

USING COMPRESSION

Hard Compression of Vocal Tracks.

By compressing vocal source material hard a very distinct and precise but less dynamic track will be the result. For this purpose we need the Compressor to work practically all the time. Therefore the Threshold must be set rather low, the Ratio rather high and the Attack time short. The release time setting again depends on what it is you would like to achieve. If you with this “hard compression scenario” wishes to hear e.g. the singer taking the next breath in between his/hers actual singing a short Release time should be your choice. A long release time on the other hand would compensate for this

Guideline Settings

Ratio: 5-6:1

Attack: 5ms

Release: 100ms

Controlling Percussive Material

When using compression on e.g. a snare drum entirely different aspects are to be taken in consideration compared to vocal processing. A drum has a sharp attack but almost no durance. For the Compressor to take effect at all a really short Attack time is essential. The Threshold can be set relatively low as you probably want to process all snare- drum hits. The Ratio setting for this application is really where you can add different characteristics on the signal. The higher a Ratio setting the more flat but distinct a sound you can create. Too high a Ratio setting allows only a small amount of the source materials original characteristics to be maintained.

Guideline Settings

Ratio: 4:1

Attack: 1.0 ms

Release: 100ms

Makeup Gain

When a signal is compressed the max Output level of the signal is reduced. Since it is a reduction in dynamic content and not a gain-reduction that is the object of applying compression a make-up gain is necessary to lift the signal to appropriate level.

Also when using the bypass function for comparing the unprocessed signal with the processed signal equal level for these modes is essential.

The meters on the TRIPLE•C are excellent tools to achieve this. Lets have a closer look at the meters.

When no signal passes through the unit the gain is illustrated like this:

Try turning the Make-up Level knob to change the level.

If no compression is applied you are now actually changing the Output level.

When the signal is processed/compressed the Output level is reduced. The amount of gain reduction/compression applied is illustrated via the via the meters like this: (example in Multi-band mode)

To achieve the same Output level on the processed signal as on the unprocessed signal simply turn up the Makeup Gain level knob until the max gain reduction is at the 0dB marker.

This will look approximately like this :

This is how easy it is to apply Make-up gain using the TRIPLE•C.

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Triplec Page Table of Contents Page Introduction Front Panel Look Ahead key Envelope Mode keyRatio knob Attack knobSingle Version Rear PanelStereo Version Midi CableSignal Flow Setting up the Triplec Triplec SetupsTriplec in a Digital Insert Triplec Stereo version in a Group InsertEQ Insert in the Triplec Sidechain Stereo Setup Using two Triplec Single ChannelsSide Chain On Triplec Display Setup SetupProgram bank Midi CC Range On/OffBulk Dump SysEx IDRecall Recall Edit StoreEdit StoreInput Section FULL-RANGE ModeDynamic Section Makeup Gain SectionExternal Sidechain Edit MenuSpectral Adjust MULTI-BAND ModeTo select Multi-band mode Peak TypeMeters Makeup GainHi X-Over Lo X-OverTo select the Envelope mode Envelope ModeEnvelope Attack Gain Sustain PeriodHi X-Over, Lo X-Over and Comp Style are Stereo Link Sidechain OperationExternal EQ Compression in general Using Compression IntroductionCompressors vs Limiters Multi-band CompressionSpectral Adjust Section Using CompressionSelecting Full-range or Multi-band mode Better Definition of Vocal materialControlling Percussive Material Hard Compression of Vocal TracksMakeup Gain Voltage Line plug according to standard Important Safety InstructionsFor the customers in Canada ServiceCertificate Of Conformity Appendix Midi Implementation Chart Midi CC Appendix Midi Control ChangesDigital Inputs and Outputs General Appendix Technical SpecificationsPreset List
Top Page Image Contents