TC electronic SDN BHD SDN BHD user manual Triplec Display

THE TRIPLE•C DISPLAY

Overload LEDs	Input Type	Sync	Gain	Envelope
	Indicator	Indicator	Metering	Processing
				Limiter
				Indicator
				Envelope
				Setting
				Link Mode
				MIDI
				Override
				Absolute Gain

Input Meter Output Meter Current Clock Status Alpha/Numeric Display

Input/Output meters

Peak meter showing Input and Output level. The Meter range is: 0, -3, -6 ,-12, -18, -24, -40dB.

Input Overload LED

The OVERLOAD LED indicates one of two situations: The Input level is too hot and therefore overloading or there is an internal DSP overflow. The Overload LED is lit when 1 sample is @ 0dBFS.

Output Overload LED

Indicates when the Output is too hot. This will occur if e.g. too much gain has been added through the TRIPLE•C. The Overload LED is lit when 1 sample is @ 0dBFS.

Input - Analog/Digital

Indicates whether the TRIPLE•C is set to analog or digital Input. When set to digital Input, the Sample Rate automati- cally switches to DI. In case of no or unacceptable clock the "Digital" and "DI" icon will be blinking.

Sync

Indicates the current clock of the TRIPLE•C. When locked to an external clock, the "DI" icon is lit and the incoming Sample Rate is displayed by either the 44.1 or 48 icon.

If no or unacceptable clock is available, the "Digital" and "DI" icons will be blinking.

Link indicator

Indicates that the unit is linked to a second TRIPLE•C.

MIDI

When MIDI information is received the MIDI icon will blink.

Gain Metering

The Gain meter indicates the total gain through the TRIPLE•C and simultaneously shows the applied gain reduction.

Envelope Setting

Indicates the setting of the Envelope Mode. Please see Envelope chapter for further information.

Trig

Indicates when the Envelope function is processing the incoming signal.

Limit

When the LIMIT LED is lit the Softclipper is active.

Override

When recalling a preset it is most likely that eg. Threshold, Ratio, Attack and Release settings do not match the positions of the corresponding knobs on the front. When turning one of these knobs the current value is displayed in the display and the OVERRIDE LED will blink until you pass the “knob-position” that matches the actual parameter setting. When this “match-point” is passed the parameter can be adjusted.

12