Faber Island Mount Canopy Rangehood Wiring Diagram, USE and Care Information

WIRING DIAGRAM

• This rangehood uses 20 watt halogen lamps.

USE AND CARE INFORMATION

This rangehood system is designed to remove smoke, cooking vapors and odors from the cooktop area.

Rangehood Control Panel

The control panel is located on top of the rangehood canopy. The position and function of each control button are indicated in FIGURE 15.

Rangehood Control Panel

The control panel is located on top of the rangehood canopy. The position and function of each control button are indicated in FIGURE 15.

Light On/Off Button ( L )

On/Off switch for the halogen light. Move the switch to "1" to turn the light ON and to "0" to turn it OFF.

Blower On/Off Button ( M )

On/Off switch for the blower. Move the switch to "1" to turn the blower ON and to "0" to turn it OFF.

Blower Speed Button ( V )

Speed control for blower. Moving the switch to the 1 Position turns the blower on LOW. Moving the switch to the 2 Position turns the blower on MEDIUM. Moving the switch to the 3 Position turns the blower on HIGH.

For Best Results

Start the rangehood several minutes before cooking to develop proper airflow. Allow the unit to operate for several minutes after cooking is complete to clear all smoke and odors from the kitchen.

Cleaning

The stainless steel grease filters should be cleaned frequently in hot detergent solution or washed in the dishwasher. Stainless steelcleanershouldbeusedonstainlessrangehoods. Abrasives and scouring agents can scratch stainless steel finishes and should not be used to clean finished surfaces.

Replacing the Lamps

Before attempting to replace the lamps, make sure that the light switch is turned off. Remove the 2 screws (as indicated in FIGURE 16) that hold the light support and gently pull the support down from the hood. Remove the lamp from the light support and replace with new lamp. Replace the light support and fix it into place with the 2 screws.

An alternative method to replace the lamps is to use a 1 1/4" suction cup (FIGURE 17).Attach the suction cup to the bulb and pull firmly down on the bulb and replace with a new lamp.

1 2 1 21 2 3

L MV

FIGURE 15

FIGURE 16

FIGURE 17

Version 3/08 - Page 9