Texas Instruments SLAU081 Switch Settings, Default Description Configuration, Jumper Settings

			Shipping (Default Configuration)
Table 2–1. Default Switch Settings
			Switch Settings
		Default	Description
		Configuration
	SW1-1	On	Stand-alone mode is selected, LED is on
	SW1-2	Off	Reserved
	SW1-3	Off	Reserved
	SW1-4	Off	Reserved

Table 2–2. Default Jumper Settings

			Jumper Settings
	Default Configuration		Description
	Pins 1–2	Pins 2–3
W1	Inserted	Not inserted	Input for channel 0 is via BNC connector J1.
W2	Not inserted	Inserted	Sine wave test signal is selected for channel 0.
W3	Not inserted	Inserted	Sine wave test signal is output for channel 0.
W4	Not inserted	Inserted	Onboard conditioned input for channel 0 is selected.
W5	Not populated		Not populated
W6	Not populated		Not populated
W7	Not populated		Not populated
W8	Not populated		Not populated
W9	Not inserted		Disables onboard sine and triangle wave generator
W10	Inserted	Not inserted	SCLK routed to ADC
W11	Not inserted	Inserted	Signal conditioning output selected for channel 0
W12	Inserted	Not inserted	FS routed to ADC
W13	Not Inserted		5-V analog
W14	Inserted		EVM reference or DAC’s on-chip reference selected.
W15	Not populated		Not populated
W16	Inserted	Not inserted	Selects internal or external reference
W17	Inserted	Not inserted	Determines EVM reference voltage
W18	Not inserted	Inserted	FS routed to DAC
W19	Inserted	Not inserted	Selects source of signal conditioning output from DAC
W20	Not inserted
W21	Inserted	Not inserted	These jumpers determine various options for supplying system
W22	Inserted	Not inserted
			clock. This has been designed to be as flexible as possible to
W23	Inserted	Not inserted	accommodate many potential options.
W24	Not inserted
W25	Not populated		Not populated

The hardware that can be reconfigured falls into one of the following sections:

-Jumpers

-Switches

-Connectors

Getting Started 2-3