What to do if…
The dishwasher will not start or stops during operation. Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the indications de- scribed in the chart, without calling out an engineer.
Display message and malfunction
•intermitted audible signal
•message OPEN THE TAP in the display
The dishwasher does not fill with water
•intermitted audible signal
•message DRAIN BLOCKED in the display
The dishwasher will not drain
•intermitted audible signal
• appears in the display
The programme does not start.
Switch off the dishwasher, open the door and carry out the following suggested corrective ac- tions.
Possible cause and solution
•The water tap is blocked or furred with limescale. Clean the water tap.
•The water tap is turned off. Turn the water tap on.
•The filter (where present) in the threaded hose fitting at the water inlet valve is blocked.
Clean the filter in the threaded hose.
•The water inlet hose has not been correctly laid or it is bent or squashed.
Check the water inlet hose connection.
•The sink spigot is blocked. Clean out the sink spigot.
•The water drain hose has not been correctly laid or it is bent or squashed.
Check the water drain hose connection.
•Close the water tap and contact your local Service Force Centre.
•The dishwasher’s door has not been properly closed. (Message PLEASE CLOSE DOOR dis- played). Close the door.
•The main plug is not plugged in. Insert the main plug.
•The fuse has blown out in the household fuse box. Replace the fuse.
•Delay start has been set.
If dishes are to be washed immediately, cancel the delay start.
21