Zanussi ZDI 600 QX manual Drain hose, Electrical connection

Page 26

Drain hose

Connect drain hose to the

Required height: 30 to 100

Ensure that the hoses are

When connecting the

sink.

cm above bottom of the

not kinked, crushed or en-

drain hose to an under

 

dishwasher.

tangled.

sink trap spigot, the entire

 

 

 

plastic membrane (A)

 

 

 

must be removed. Fail-

 

 

 

ure to remove all the mem-

 

 

 

brane will result in food

 

 

 

particles building up over

 

 

 

time eventually blocking

 

 

 

the dishwasher drain hose

 

 

 

spigot.

If you use a drain hose extension the total length should not be longer than 4 metres. Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided.

Electrical connection

CAUTION!

Safety standards require the appliance to be earthed.

Prior to using the appliance for the first time, ensure that the rated voltage and type of supply on the rating plate match that of the supply where the appliance is to be installed.

The fuse rating is also to be found on the rating plate.

Always plug the mains plug into a correctly in- stalled shockproof socket. Multi-way plugs, connectors and extension cables must not be used.

This could constitute a fire hazard through over- heating.

If necessary, have the domestic wiring system socket replaced. In case that the electrical ca- ble has to be replaced, contact your local Serv- ice Force centre.

The plug must be accessible after the appliance has been installed.

Never unplug the appliance by pulling on the cable. Always pull the plug.

The manufacturer accepts no liability for failure to observe the above safety precautions.

26

Image 26
Contents Dishwasher ZDI 600 QX Contents Child safety Safety informationGeneral safety Correct useInstallation Control panelLanguage Option submenu DisplayOption menu Symbols have the following meaning Select and start a washing programmeEnd of the washing programme Cancel a delay start or a washing programme in progressWashing programmes First use Plate Warmer PrewashUse of salt Set the water softenerClarke Water hardness Mmol/l Use of dishwasher salt Setting the water softener manually see tableSetting electronically Use of rinse aid Adjusting the dosage of rinse aid Load cutlery and dishesAre of limited suitability Are not suitableLower basket Adjusting the height of the upper basketMaximum height of the dishes Upper basket Use of detergent To move to the higher position proceed as followsMultitab function Detergent tabletsUnloading the dishwasher Care and cleaningCleaning the filters Internal cleaning Cleaning the spray armsExternal cleaning Prolonged periods of non- operationMoving the machine Frost precautionsEnvironment concerns Packaging materialDisplay message and malfunction Possible cause and solutionWhat to do if… Wash results are not satisfactory Technical data Consumption valuesHints for test institutes InstallationFull load 12 standard place settings Fitting under a counterWater connection Water inlet hose with safety valveLevelling Drain hose Electrical connectionPage 117972120-012008