H. REMOVING THE TURNTABLE MOTOR
1)Remove the turntable and rotating ring.
2)Lay the unit down on its back.
3)Remove the turntable motor cover.
The turntable base cover is easily removed by pinching the eight parts with a wire cutting.
4)Disconnect the leadwire from the turntable motor terminals.
5)Remove the screw securing the turntable motor to the oven cavity ASS’Y
6)After repairing the motor, rotate the removed turntable motor cover.
7)Fit the turntable motor cover’s projecting part to the base plate slit.
8)The taptite screw shall be used when a turntable motor cover is secured with a screw.
NOTE:
1.Remove the wire lead from the turntable motor VERY CAREFULLY.
2.Be sure to grasp the connector, not the wires, when removing.
Taptite Screw |
Wire Leads |
Turntable Motor |
I. HIGH VOLTAGE TRANSFORMER REMOVAL
1)Discharge the high voltage capacitor.
2)Disconnect the leadwire from magnetron, high voltage transformer, and capacitor.
3)Remove the screw holding the high voltage transformer to the baseplate.
J. FAN MOTOR ASSEMBLY REMOVAL
1)Discharge the high voltage capacitor.
2)Disconnect the leadwire from fan motor and high voltage capacitor.
3)Remove the two screws holding the the suction guide ASS’Y to the oven cavity and remove the high voltage diode earth screw.
4)Remove the two screws holding the fan motor ASS’Y to the suction guide ASS’Y.
K. HIGH VOLTAGE CAPACITOR AND DIODE REMOVAL
1)Discharge the high voltage capacitor.
2)Disconnect the leadwire from fan motor and high voltage capacitor.
3)Remove the screw holding the suction guide ASS’Y to the oven cavity and remove the high voltage diode earth screw.
4)Remove the screw holding the high voltage capacitor bracket.
Fan Motor |
ASS'Y |
Suction |
Guide |
H.V. |
Transformer |
H.V. |
Diode |