Frigidaire LCRT2010ST service manual High Voltage, Capacitor, Diode

Page 20

COMPONENTS

TEST PROCEDURE

RESULTS

Antenna

Gasket

Chassis

		Filament

	NOTE: When testing the magnetron, be sure to install the magnetron gasket
	in the correct position and be sure that the gasket is in good condition.


HIGH VOLTAGE	Measure the resistance.	Normal: Momentarily indicates
CAPACITOR	(Ohm-meter scale: Rx1000)	several ohms, and
	• Terminal to terminal.	then gradually returns
		to infinite.

Measure the resistance.	Normal: Infinite.
(Ohm-meter scale: Rx1000)
• Terminal to case.

HIGH VOLTAGE	Measure the continuity (Forward).		Normal: Continuity.
DIODE	(Ohm-meter scale: Rx10000)		Abnormal: Infinite.

NOTE :
Some inexpensive meters
may indicate infinite
resistance in both direction.	Measure the continuity (Reverse).	Normal: Infinite.
	(Ohm-meter scale: Rx10000)	Abnormal: Continuity.

5-10

Image 20

Contents Microwave Oven Safety Precautions Microwave RadiationContents Specifications DescriptionMicrowave Radiation AntennaGrounding Instructions InstallationsInstalling Control Panel FeaturesOperating Instructions Operating Sequence Schematic Diagram Circuit Description General DetailsMicrowave Leakage Test Service InformationTools and Measuring Instruments Record Keeping and Notification After Measurement Special TIPMeasurement of Microwave Power Output Disassembly and AdjustmentPower Supply Cord Control Panel AssemblyPCB Assembly Removal Door Main Assembly / RemovalRemoving Sensor AIR Duct Assembly / RemovalMagnetron Removal FAN Motor Assembly Removal Removing the Turntable MotorHigh Voltage Transformer Removal High Voltage Capacitor and Diode RemovalInterlock System Interlock MechanismPrimary Interlock Switch Test Secondary Interlock Switch TestMonitor Switch Test Components Test Procedure ResultsComponent Test Procedure Components Test ProcedureFilament Winding Primary Terminal MagnetronDiode High VoltageCapacitor Power RelayLevel FAN MotorTrouble Shooting Condition Cause RemedyCondition Check Result CauseMalfunction of secondary switch Condition Check Result Cause RemedySetting time does not count down when touching Start pad Check Result Exploded View IntroductionDoor Parts Controller Parts Oven Cavity Parts Latch Board Parts Interior Parts 50FZZABase Plate Parts Sensor Parts