Removing and replacing the lift-off oven door
CAUTION
The door is heavy. For safe, temporary storage, lay the door fl at with the inside of the door facing down.
To Remove Oven Door:
1.Open oven door completely (horizontal with fl oor -
See Figure 1).
2.Pull the door hinge locks on both left and right door hinges down from the oven frame completely towards the oven door (See Figure 2). A tool such as a small fl
3.Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - See Figure 3).
4.Close the door to the broil stop position (the oven door will stop into this position just before fully closing).
5.With the oven door in the broil stop position, lift the oven door hinge arms over the roller pins located on each side of the oven frame (See Figure 4).
To Replace Oven Door:
1.Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - See Figure 3).
2.Holding the oven door at the same angle as the removal position, seat the hook of the hinge arm over the roller pins located on each side of the oven door frame (See Figure 4). The hook of the hinge arms must be fully seated onto the roller pins.
3.Fully open the oven door (horizontal with fl oor - See
Figure 1).
4.Push the door hinge locks up towards and into the oven frame on both left and right oven door hinges (See Figure 2) to the locked position.
5.Close the oven door.
Door Hinge locations
with oven door fully open
CARE & CLEANING
Around
Oven door |
|
Hinge |
|
Figure 3 | Figure 4 |
Special door care instructions- doors contain glass that can break.
Read the following recommendations:
1.Do not close the oven door until all the oven racks are fully in place.
2.Do not hit the glass with pots, pans, or any other object.
3.Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later time.
Changing oven light
CAUTION
Be sure the oven is unplugged and all parts are COOL before replacing the oven light bulb. Do not turn the oven light on during a
On some models an interior oven light will turn on automatically when the oven is opened. The oven light may be turned on when the door is closed by using the oven light switch located on the Electronic Oven control. The oven light bulb is covered with a glass shield held in place by a wire holder. THIS GLASS SHIELD MUST ALWAYS BE IN PLACE WHEN THE OVEN IS IN USE.
CAUTION
BE SURE OVEN IS COOL
To Replace the Light Bulb:
1.Turn the power off at the main source.
2.Wear a
3.Replace bulb with a 40 Watt appliance bulb only.
4. For
Figure 1
Figure 2
press wire holder to one side to release glass shield, change bulb and be sure to replace glass shield.
33